[PATCH net-next 1/2] net: dsa: mt7530-mdio: read PHY address of switch from device tree

Arınç ÜNAL arinc.unal at arinc9.com
Sat Apr 13 22:59:11 PDT 2024


On 14.04.2024 06:10, Daniel Golle wrote:
> On Sun, Apr 14, 2024 at 01:08:19AM +0300, Arınç ÜNAL via B4 Relay wrote:
>> From: Arınç ÜNAL <arinc.unal at arinc9.com>
>>
>> Read the PHY address the switch listens on from the reg property of the
>> switch node on the device tree. This change brings support for MT7530
>> switches on boards with such bootstrapping configuration where the switch
>> listens on a different PHY address than the hardcoded PHY address on the
>> driver, 31.
>>
>> As described on the "MT7621 Programming Guide v0.4" document, the MT7530
>> switch and its PHYs can be configured to listen on the range of 7-12,
>> 15-20, 23-28, and 31 and 0-4 PHY addresses.
>>
>> There are operations where the switch PHY registers are used. For the PHY
>> address of the control PHY, transform the MT753X_CTRL_PHY_ADDR constant
>> into a macro and use it. The PHY address for the control PHY is 0 when the
>> switch listens on 31. In any other case, it is one greater than the PHY
>> address the switch listens on.
>>
>> Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
> 
> See minor nit inline below.
> 
> Reviewed-by: Daniel Golle <daniel at makrotopia.org>
> Tested-by: Daniel Golle <daniel at makrotopia.org>
> (only MT7530 and MT7531 on address 0x1f has been tested, I don't have
> any board configuring the switch to any other base-address)
> 
>> ---
>>   drivers/net/dsa/mt7530-mdio.c | 28 ++++++++++++++--------------
>>   drivers/net/dsa/mt7530.c      | 35 ++++++++++++++++++++++-------------
>>   drivers/net/dsa/mt7530.h      |  4 +++-
>>   3 files changed, 39 insertions(+), 28 deletions(-)
>>
>> diff --git a/drivers/net/dsa/mt7530.h b/drivers/net/dsa/mt7530.h
>> index 585db03c0548..76adc9d21bcf 100644
>> --- a/drivers/net/dsa/mt7530.h
>> +++ b/drivers/net/dsa/mt7530.h
>> @@ -625,7 +625,7 @@ enum mt7531_clk_skew {
>>   #define  MT7531_PHY_PLL_OFF		BIT(5)
>>   #define  MT7531_PHY_PLL_BYPASS_MODE	BIT(4)
>>   
>> -#define MT753X_CTRL_PHY_ADDR		0
>> +#define MT753X_CTRL_PHY_ADDR(phy_addr)	(phy_addr == 0x1f ? 0 : phy_addr + 1)
> 
> #define MT753X_CTRL_PHY_ADDR(phy_addr)	(phy_addr + 1 & 0x1f)
> 
> It's shorter, and works without conditional operator which is expensive.

Great, thanks.

Arınç



More information about the linux-arm-kernel mailing list