[PATCH 2/4] arm64: dts: ti: k3-j721e-mcu: Add the MCU domain watchdog instances

[Neha Malcom Francis]

Hi Udit,

On 10/04/24 11:15, Kumar, Udit wrote:
> Hi Neha
> 
> On 3/26/2024 5:57 PM, Neha Malcom Francis wrote:
>> There are 2 watchdog instances in the MCU domain. These instances are
>> coupled with the MCU domain R55 instances. Reserve them as they are not
>> used by A72.
>>
>> Signed-off-by: Neha Malcom Francis <n-francis at ti.com>
>> ---
>>   .../boot/dts/ti/k3-j721e-mcu-wakeup.dtsi      | 26 +++++++++++++++++++
>>   1 file changed, 26 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi 
>> b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
>> index b0f41e9829cc..867f307909be 100644
>> --- a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
>> +++ b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
>> @@ -694,4 +694,30 @@ wkup_esm: esm at 42080000 {
>>           compatible = "ti,j721e-esm";
>>           reg = <0x00 0x42080000 0x00 0x1000>;
>>       };
>> +
>> +    /*
>> +     * The 2 RTI instances are couple with MCU R5Fs so keeping them
>> +     * reserved as these will be used by their respective firmware
>> +     */
>> +    mcu_watchdog0: watchdog at 40600000 {
>> +        compatible = "ti,j7-rti-wdt";
>> +        reg = <0x00 0x40600000 0x00 0x100>;
>> +        clocks = <&k3_clks 262 1>;
>> +        power-domains = <&k3_pds 262 TI_SCI_PD_EXCLUSIVE>;
>> +        assigned-clocks = <&k3_clks 262 1>;
>> +        assigned-clock-parents = <&k3_clks 262 5>;
>> +        /* reserved for MCU_R5F0_0 */
>> +        status = "reserved";
>> +    };
>> +
>> +    mcu_watchdog1: watchdog at 40610000 {
>> +        compatible = "ti,j7-rti-wdt";
>> +        reg = <0x00 0x40610000 0x00 0x100>;
>> +        clocks = <&k3_clks 263 1>;
>> +        power-domains = <&k3_pds 263 TI_SCI_PD_EXCLUSIVE>;
>> +        assigned-clocks = <&k3_clks 263 1>;
>> +        assigned-clock-parents = <&k3_clks 263 5>;
>> +        /* reserved for MCU_R5F0_1 */
> 
> Table 12-22642. MCU_RTI Hardware Requests (In same TRM referred in 3/4 patch 
> review ),
> 
> says each WDT has destination of MCU0_R5_CORE0 and MCU0_R5_CORE1
> 
> Please suggest, if fw level this is decided to reserved like above ?
> 
> With that clarification, Please use
> 
> Reviewed-by: Udit Kumar <u-kumar1 at ti.com>
> 
> 

At firmware level, the MCU R5 is in lockstep mode. The dual destination of the 
WDT interrupt makes sense then.

>> +        status = "reserved";
>> +    };
>>   };

-- 
Thanking You
Neha Malcom Francis