[PATCH 2/2] arm64: dts: rockchip: add Protonic MECSBC device-tree

Andrew Lunn andrew at lunn.ch
Fri Apr 5 06:35:52 PDT 2024


> Do you have a pointer why setting the delays in the phy is preferred
> over setting them in the network driver? In the end this requires us
> to have the correct phy driver whereas setting them in the network
> driver would just work for any phy driver?

One reason is that nearly every other board does it in the PHY. This
is something i've been trying to standardize on for years.

Another point is that when doing it in the MAC, most MAC drivers get
it wrong. RGMII needs 2ns delays on the clock lines. That delay can be
provided by the board, making the clock lines longer. Or the MAC or
the PHY can add the delays. phy-mode in DT tells you about what the
board requires. Your board does not have extra long clock lines, so
you need rgmii-id. If the MAC decides to implement the delay, it
should modify the value passed to the PHY to be rgmii, to indicate it
has added the delays, and the PHY should not. This is what many MAC
drivers get wrong, they don't do the masking. By standardizing on the
PHY doing the delay, we avoid this, keeping the MAC driver simple, and
probably bug free in this respect.

There is admittedly some historical confusion here. The design is not
the best. If would of been much better if the design would have both
phy-mode and mac-mode.

As for using genphy, yes it might work, but there is no real
guarantee. It is always best you drive the hardware using the driver
specific to it. Consider genphy as a fallback which might be good
enough that you can ssh into the board and install the correct
module. You should not really be using it in production.

	Andrew



More information about the linux-arm-kernel mailing list