[PATCH v2] arm64: dts: debix-a: Disable i2c2 in base .dts

[Laurent Pinchart]

From: Jacopo Mondi <jacopo at jmondi.org>

The I2C2 bus is used for the CSI and DSI connectors only, no devices are
connected to it on neither the Debix Model A nor its IO board. Disable
the bus in the board's .dts and remove its clock frequency settings, as
the value depends solely on the devices conncted to the CSI and DSI
connectors. Display panel or camera sensor overlays will configure and
enable the bus when necessary.

Signed-off-by: Jacopo Mondi <jacopo at jmondi.org>
Signed-off-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
Reviewed-by: Kieran Bingham <kieran.bingham at ideasonboard.com>
---
Changes since v1:

- Don't drop the bus, just disable it
---
 arch/arm64/boot/dts/freescale/imx8mp-debix-model-a.dts | 2 --
 1 file changed, 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mp-debix-model-a.dts b/arch/arm64/boot/dts/freescale/imx8mp-debix-model-a.dts
index 2c19766ebf09..9b8f97a84e61 100644
--- a/arch/arm64/boot/dts/freescale/imx8mp-debix-model-a.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mp-debix-model-a.dts
@@ -197,10 +197,8 @@ ldo5: LDO5 {
 };
 
 &i2c2 {
-	clock-frequency = <100000>;
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_i2c2>;
-	status = "okay";
 };
 
 &i2c3 {

base-commit: 4cece764965020c22cff7665b18a012006359095
-- 
Regards,

Laurent Pinchart