[PATCH net-next v6 07/10] net: ti: icssg-prueth: Adjust the number of TX channels for SR1.0

[Diogo Ivo]

As SR1.0 uses the current higher priority channel to send commands to
the firmware, take this into account when setting/getting the number
of channels to/from the user.

Based on the work of Roger Quadros in TI's 5.10 SDK [1].

[1]: https://git.ti.com/cgit/ti-linux-kernel/ti-linux-kernel/tree/?h=ti-linux-5.10.y

Co-developed-by: Jan Kiszka <jan.kiszka at siemens.com>
Signed-off-by: Jan Kiszka <jan.kiszka at siemens.com>
Signed-off-by: Diogo Ivo <diogo.ivo at siemens.com>
Reviewed-by: Roger Quadros <rogerq at kernel.org>
Reviewed-by: MD Danish Anwar <danishanwar at ti.com>
---
Changes in v5:
 - Restrict number of TX channels to 1 to avoid timeouts
 - Added Reviewed-by tag from Danish 

Changes in v4:
 - Add Reviewed-by from Roger

Changes in v3:
 - Address Roger's comments on SR1.0 handling

 drivers/net/ethernet/ti/icssg/icssg_ethtool.c | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/drivers/net/ethernet/ti/icssg/icssg_ethtool.c b/drivers/net/ethernet/ti/icssg/icssg_ethtool.c
index 9a7dd7efcf69..ca20325d4d3e 100644
--- a/drivers/net/ethernet/ti/icssg/icssg_ethtool.c
+++ b/drivers/net/ethernet/ti/icssg/icssg_ethtool.c
@@ -142,6 +142,9 @@ static int emac_set_channels(struct net_device *ndev,
 
 	emac->tx_ch_num = ch->tx_count;
 
+	if (emac->is_sr1)
+		emac->tx_ch_num++;
+
 	return 0;
 }
 
@@ -152,8 +155,17 @@ static void emac_get_channels(struct net_device *ndev,
 
 	ch->max_rx = 1;
 	ch->max_tx = PRUETH_MAX_TX_QUEUES;
+
+	/* Disable multiple TX channels due to timeouts
+	 * when using more than one queue */
+	if (emac->is_sr1)
+		ch->max_tx = 1;
+
 	ch->rx_count = 1;
 	ch->tx_count = emac->tx_ch_num;
+
+	if (emac->is_sr1)
+		ch->tx_count--;
 }
 
 static const struct ethtool_rmon_hist_range emac_rmon_ranges[] = {
-- 
2.44.0