[PATCH 3/8] arm64: dts: qcom: ipq5332: Add USB Super-Speed PHY node

[Dmitry Baryshkov]

On 29/09/2023 11:42, Praveenkumar I wrote:
> Add USB Super-Speed UNIPHY node and populate the phandle on
> gcc node for the parent clock map.
> 
> Signed-off-by: Praveenkumar I <quic_ipkumar at quicinc.com>
> ---
>   arch/arm64/boot/dts/qcom/ipq5332.dtsi | 25 ++++++++++++++++++++++++-
>   1 file changed, 24 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/qcom/ipq5332.dtsi b/arch/arm64/boot/dts/qcom/ipq5332.dtsi
> index d3fef2f80a81..b08ffd8c094e 100644
> --- a/arch/arm64/boot/dts/qcom/ipq5332.dtsi
> +++ b/arch/arm64/boot/dts/qcom/ipq5332.dtsi
> @@ -158,6 +158,29 @@ usbphy0: phy at 7b000 {
>   			status = "disabled";
>   		};
>   
> +		usbphy1: phy at 4b0000 {

Are there other USB PHYs on this platform?

> +			compatible = "qcom,ipq5332-usb-uniphy";
> +			reg = <0x4b0000 0x800>;
> +
> +			clocks = <&gcc GCC_PCIE3X1_PHY_AHB_CLK>,
> +				 <&gcc GCC_USB0_PHY_CFG_AHB_CLK>,
> +				 <&gcc GCC_USB0_PIPE_CLK>;
> +			clock-names = "ahb",
> +				      "cfg_ahb",
> +				      "pipe";
> +
> +			resets =  <&gcc GCC_USB0_PHY_BCR>;
> +
> +			#clock-cells = <0>;
> +			clock-output-names = "usb0_pipe_clk_src";

I'm not sure, what is the best approach her. For QMP USB and PCIe PHYs 
we had to use fixed names historically. On the other hand for QMP DP 
clocks we are fine with the generated names. I'd prefer the latter case.

> +
> +			qcom,phy-usb-mux-sel = <&tcsr 0x10540>;
> +
> +			#phy-cells = <0>;
> +
> +			status = "disabled";
> +		};
> +
>   		qfprom: efuse at a4000 {
>   			compatible = "qcom,ipq5332-qfprom", "qcom,qfprom";
>   			reg = <0x000a4000 0x721>;
> @@ -200,7 +223,7 @@ gcc: clock-controller at 1800000 {
>   				 <&sleep_clk>,
>   				 <0>,
>   				 <0>,
> -				 <0>;
> +				 <&usbphy1>;
>   		};
>   
>   		tcsr_mutex: hwlock at 1905000 {

-- 
With best wishes
Dmitry