[PATCH v4 2/2] drm/bridge: imx: add driver for HDMI TX Parallel Video Interface

[Luca Ceresoli]

Hi Lucas,

On Thu, 28 Sep 2023 14:55:36 +0200
Lucas Stach <l.stach at pengutronix.de> wrote:

> This IP block is found in the HDMI subsystem of the i.MX8MP SoC. It has a
> full timing generator and can switch between different video sources. On
> the i.MX8MP however the only supported source is the LCDIF. The block
> just needs to be powered up and told about the polarity of the video
> sync signals to act in bypass mode.
> 
> Signed-off-by: Lucas Stach <l.stach at pengutronix.de>
> Reviewed-by: Luca Ceresoli <luca.ceresoli at bootlin.com> (v2)

I was in Cc on your v3 but not on this v4. Maybe the " (v2)" on these
lines confuses get_maintainers.pl?

> Tested-by: Marek Vasut <marex at denx.de> (v1)
> Tested-by: Luca Ceresoli <luca.ceresoli at bootlin.com> (v2)
> Tested-by: Richard Leitner <richard.leitner at skidata.com> (v2)
> Tested-by: Frieder Schrempf <frieder.schrempf at kontron.de> (v2)
> Reviewed-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com> (v3)

A changelog would be appreciated, especially as a long time has gone
since I last looked at these patches.

Confirmed for this v4:

Reviewed-by: Luca Ceresoli <luca.ceresoli at bootlin.com>
[On Avnet MSC SM2-MB-EP1 based on the SMARC module]
Tested-by: Luca Ceresoli <luca.ceresoli at bootlin.com>

Luca

-- 
Luca Ceresoli, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com