[PATCH v4 2/5] thermal/drivers/mediatek/lvts_thermal: Add suspend and resume

[Alexandre Mergnat]

On 23/08/2023 09:48, Daniel Lezcano wrote:
> On 31/05/2023 10:05, AngeloGioacchino Del Regno wrote:
> 
> [ ... ]
> 
>>>   static const struct lvts_ctrl_data mt8195_lvts_mcu_data_ctrl[] = {
>>>       {
>>>           .cal_offset = { 0x04, 0x07 },
>>> @@ -1268,6 +1300,8 @@ MODULE_DEVICE_TABLE(of, lvts_of_match);
>>>   static struct platform_driver lvts_driver = {
>>>       .probe = lvts_probe,
>>>       .remove = lvts_remove,
>>> +    .suspend = lvts_suspend,
>>
>> Should we do that in noirq handlers?
>> We're risking to miss a thermal interrupt.
> 
> I'm not sure missing a thermal interrupt is a problem in this context 
> but we may go in the irq routine with an undefined state sensor setup 
> (eg. the internal clock stopped in the suspend and then read the sensor 
> in the isr).
> 
> IMO, using suspend_noirq and resume_noirq may be required here.
> 
> Alexandre are you taking over the next iteration?
> 
> 

Hi Daniel,

Sorry I missed your message...
I don't think taking over the next iteration, Bernhard should continue. 
Let me check internally to be sure. As I understood, the next change 
should be heavy.

-- 
Regards,
Alexandre