[PATCH 2/3] arm64: dts: ti: k3-am68-sk: Add DT node for PCIe

[Ravi Gunasekaran]

From: Sinthu Raja <sinthu.raja at ti.com>

AM68 Starter kit features with one PCIe M.2 Key M connector
interfaced via two SerDes lanes. Update the SerDes configuration
for PCIe.

Signed-off-by: Sinthu Raja <sinthu.raja at ti.com>
Signed-off-by: Ravi Gunasekaran <r-gunasekaran at ti.com>
---
 .../boot/dts/ti/k3-am68-sk-base-board.dts     | 29 +++++++++++++++++++
 1 file changed, 29 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
index 5df5946687b3..81c2307c77f9 100644
--- a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
@@ -553,3 +553,32 @@
 		};
 	};
 };
+
+&serdes_ln_ctrl {
+	idle-states = <J721S2_SERDES0_LANE0_PCIE1_LANE0>, <J721S2_SERDES0_LANE1_PCIE1_LANE1>,
+		      <J721S2_SERDES0_LANE2_USB_SWAP>, <J721S2_SERDES0_LANE3_USB>;
+};
+
+&serdes_refclk {
+	clock-frequency = <100000000>;
+};
+
+&serdes0 {
+	status = "okay";
+
+	serdes0_pcie_link: phy at 0 {
+		reg = <0>;
+		cdns,num-lanes = <2>;
+		#phy-cells = <0>;
+		cdns,phy-type = <PHY_TYPE_PCIE>;
+		resets = <&serdes_wiz0 1>, <&serdes_wiz0 2>;
+	};
+};
+
+&pcie1_rc {
+	status = "okay";
+	reset-gpios = <&exp1 10 GPIO_ACTIVE_HIGH>;
+	phys = <&serdes0_pcie_link>;
+	phy-names = "pcie-phy";
+	num-lanes = <2>;
+};
-- 
2.17.1