[PATCH tty v1 50/74] serial: rda: Use port lock wrappers

[John Ogness]

From: Thomas Gleixner <tglx at linutronix.de>

When a serial port is used for kernel console output, then all
modifications to the UART registers which are done from other contexts,
e.g. getty, termios, are interference points for the kernel console.

So far this has been ignored and the printk output is based on the
principle of hope. The rework of the console infrastructure which aims to
support threaded and atomic consoles, requires to mark sections which
modify the UART registers as unsafe. This allows the atomic write function
to make informed decisions and eventually to restore operational state. It
also allows to prevent the regular UART code from modifying UART registers
while printk output is in progress.

All modifications of UART registers are guarded by the UART port lock,
which provides an obvious synchronization point with the console
infrastructure.

To avoid adding this functionality to all UART drivers, wrap the
spin_[un]lock*() invocations for uart_port::lock into helper functions
which just contain the spin_[un]lock*() invocations for now. In a
subsequent step these helpers will gain the console synchronization
mechanisms.

Converted with coccinelle. No functional change.

Signed-off-by: Thomas Gleixner <tglx at linutronix.de>
---
 drivers/tty/serial/rda-uart.c | 34 +++++++++++++++++-----------------
 1 file changed, 17 insertions(+), 17 deletions(-)

diff --git a/drivers/tty/serial/rda-uart.c b/drivers/tty/serial/rda-uart.c
index be5c842b5ba9..d824c8318f33 100644
--- a/drivers/tty/serial/rda-uart.c
+++ b/drivers/tty/serial/rda-uart.c
@@ -139,12 +139,12 @@ static unsigned int rda_uart_tx_empty(struct uart_port *port)
 	unsigned int ret;
 	u32 val;
 
-	spin_lock_irqsave(&port->lock, flags);
+	uart_port_lock_irqsave(port, &flags);
 
 	val = rda_uart_read(port, RDA_UART_STATUS);
 	ret = (val & RDA_UART_TX_FIFO_MASK) ? TIOCSER_TEMT : 0;
 
-	spin_unlock_irqrestore(&port->lock, flags);
+	uart_port_unlock_irqrestore(port, flags);
 
 	return ret;
 }
@@ -246,7 +246,7 @@ static void rda_uart_set_termios(struct uart_port *port,
 	unsigned int baud;
 	u32 irq_mask;
 
-	spin_lock_irqsave(&port->lock, flags);
+	uart_port_lock_irqsave(port, &flags);
 
 	baud = uart_get_baud_rate(port, termios, old, 9600, port->uartclk / 4);
 	rda_uart_change_baudrate(rda_port, baud);
@@ -325,7 +325,7 @@ static void rda_uart_set_termios(struct uart_port *port,
 	/* update the per-port timeout */
 	uart_update_timeout(port, termios->c_cflag, baud);
 
-	spin_unlock_irqrestore(&port->lock, flags);
+	uart_port_unlock_irqrestore(port, flags);
 }
 
 static void rda_uart_send_chars(struct uart_port *port)
@@ -408,7 +408,7 @@ static irqreturn_t rda_interrupt(int irq, void *dev_id)
 	unsigned long flags;
 	u32 val, irq_mask;
 
-	spin_lock_irqsave(&port->lock, flags);
+	uart_port_lock_irqsave(port, &flags);
 
 	/* Clear IRQ cause */
 	val = rda_uart_read(port, RDA_UART_IRQ_CAUSE);
@@ -425,7 +425,7 @@ static irqreturn_t rda_interrupt(int irq, void *dev_id)
 		rda_uart_send_chars(port);
 	}
 
-	spin_unlock_irqrestore(&port->lock, flags);
+	uart_port_unlock_irqrestore(port, flags);
 
 	return IRQ_HANDLED;
 }
@@ -436,16 +436,16 @@ static int rda_uart_startup(struct uart_port *port)
 	int ret;
 	u32 val;
 
-	spin_lock_irqsave(&port->lock, flags);
+	uart_port_lock_irqsave(port, &flags);
 	rda_uart_write(port, 0, RDA_UART_IRQ_MASK);
-	spin_unlock_irqrestore(&port->lock, flags);
+	uart_port_unlock_irqrestore(port, flags);
 
 	ret = request_irq(port->irq, rda_interrupt, IRQF_NO_SUSPEND,
 			  "rda-uart", port);
 	if (ret)
 		return ret;
 
-	spin_lock_irqsave(&port->lock, flags);
+	uart_port_lock_irqsave(port, &flags);
 
 	val = rda_uart_read(port, RDA_UART_CTRL);
 	val |= RDA_UART_ENABLE;
@@ -456,7 +456,7 @@ static int rda_uart_startup(struct uart_port *port)
 	val |= (RDA_UART_RX_DATA_AVAILABLE | RDA_UART_RX_TIMEOUT);
 	rda_uart_write(port, val, RDA_UART_IRQ_MASK);
 
-	spin_unlock_irqrestore(&port->lock, flags);
+	uart_port_unlock_irqrestore(port, flags);
 
 	return 0;
 }
@@ -466,7 +466,7 @@ static void rda_uart_shutdown(struct uart_port *port)
 	unsigned long flags;
 	u32 val;
 
-	spin_lock_irqsave(&port->lock, flags);
+	uart_port_lock_irqsave(port, &flags);
 
 	rda_uart_stop_tx(port);
 	rda_uart_stop_rx(port);
@@ -475,7 +475,7 @@ static void rda_uart_shutdown(struct uart_port *port)
 	val &= ~RDA_UART_ENABLE;
 	rda_uart_write(port, val, RDA_UART_CTRL);
 
-	spin_unlock_irqrestore(&port->lock, flags);
+	uart_port_unlock_irqrestore(port, flags);
 }
 
 static const char *rda_uart_type(struct uart_port *port)
@@ -515,7 +515,7 @@ static void rda_uart_config_port(struct uart_port *port, int flags)
 		rda_uart_request_port(port);
 	}
 
-	spin_lock_irqsave(&port->lock, irq_flags);
+	uart_port_lock_irqsave(port, &irq_flags);
 
 	/* Clear mask, so no surprise interrupts. */
 	rda_uart_write(port, 0, RDA_UART_IRQ_MASK);
@@ -523,7 +523,7 @@ static void rda_uart_config_port(struct uart_port *port, int flags)
 	/* Clear status register */
 	rda_uart_write(port, 0, RDA_UART_STATUS);
 
-	spin_unlock_irqrestore(&port->lock, irq_flags);
+	uart_port_unlock_irqrestore(port, irq_flags);
 }
 
 static void rda_uart_release_port(struct uart_port *port)
@@ -597,9 +597,9 @@ static void rda_uart_port_write(struct uart_port *port, const char *s,
 	if (port->sysrq) {
 		locked = 0;
 	} else if (oops_in_progress) {
-		locked = spin_trylock(&port->lock);
+		locked = uart_port_trylock(port);
 	} else {
-		spin_lock(&port->lock);
+		uart_port_lock(port);
 		locked = 1;
 	}
 
@@ -615,7 +615,7 @@ static void rda_uart_port_write(struct uart_port *port, const char *s,
 	rda_uart_write(port, old_irq_mask, RDA_UART_IRQ_MASK);
 
 	if (locked)
-		spin_unlock(&port->lock);
+		uart_port_unlock(port);
 
 	local_irq_restore(flags);
 }
-- 
2.39.2