[PATCH v5 08/31] dt-bindings: soc: fsl: cpm_qe: cpm1-scc-qmc: Add support for QMC HDLC

[Herve Codina]

On Wed, 13 Sep 2023 15:42:45 +0100
Conor Dooley <conor at kernel.org> wrote:

> On Wed, Sep 13, 2023 at 09:26:40AM +0200, Herve Codina wrote:
> > Hi Conor,
> > 
> > On Tue, 12 Sep 2023 18:21:58 +0100
> > Conor Dooley <conor at kernel.org> wrote:
> >   
> > > On Tue, Sep 12, 2023 at 12:10:18PM +0200, Herve Codina wrote:  
> > > > The QMC (QUICC mutichannel controller) is a controller present in some
> > > > PowerQUICC SoC such as MPC885.
> > > > The QMC HDLC uses the QMC controller to transfer HDLC data.
> > > > 
> > > > Additionally, a framer can be connected to the QMC HDLC.
> > > > If present, this framer is the interface between the TDM bus used by the
> > > > QMC HDLC and the E1/T1 line.
> > > > The QMC HDLC can use this framer to get information about the E1/T1 line
> > > > and configure the E1/T1 line.
> > > > 
> > > > Signed-off-by: Herve Codina <herve.codina at bootlin.com>
> > > > ---
> > > >  .../bindings/soc/fsl/cpm_qe/fsl,cpm1-scc-qmc.yaml   | 13 +++++++++++++
> > > >  1 file changed, 13 insertions(+)
> > > > 
> > > > diff --git a/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,cpm1-scc-qmc.yaml b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,cpm1-scc-qmc.yaml
> > > > index 82d9beb48e00..b5073531f3f1 100644
> > > > --- a/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,cpm1-scc-qmc.yaml
> > > > +++ b/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,cpm1-scc-qmc.yaml
> > > > @@ -101,6 +101,16 @@ patternProperties:
> > > >            Channel assigned Rx time-slots within the Rx time-slots routed by the
> > > >            TSA to this cell.
> > > >  
> > > > +      compatible:
> > > > +        const: fsl,qmc-hdlc
> > > > +
> > > > +      fsl,framer:
> > > > +        $ref: /schemas/types.yaml#/definitions/phandle
> > > > +        description:
> > > > +          phandle to the framer node. The framer is in charge of an E1/T1 line
> > > > +          interface connected to the TDM bus. It can be used to get the E1/T1 line
> > > > +          status such as link up/down.    
> > > 
> > > Sounds like this fsl,framer property should depend on the compatible
> > > being present, no?  
> > 
> > Well from the implementation point of view, only the QMC HDLC driver uses this
> > property.
> > 
> > From the hardware description point of view, this property means that the time slots
> > handled by this channel are connected to the framer. So I think it makes sense for
> > any channel no matter the compatible (even if compatible is not present).
> > 
> > Should I change and constraint the fsl,framer property to the compatible presence ?
> > If so, is the following correct for this contraint ?
> >    --- 8< ---
> >    dependencies:
> >      - fsl,framer: [ compatible ];
> >    --- 8< ---  
> 
> The regular sort of
> if:
> 	compatible:
> 		contains:
> 			const: foo
> then:
> 	required:
> 		- fsl,framer
> would fit the bill, no?

Not sure.
"fsl,framer" is an optional property (depending on the hardware we can have
a framer or not).

Hervé