[PATCH] net: stmmac: Wait a bit for the reset to take effect

[Bernd Edlinger]

On 10/31/23 11:32, Serge Semin wrote:
> On Mon, Oct 30, 2023 at 07:01:11AM +0100, Bernd Edlinger wrote:
>> otherwise the synopsys_id value may be read out wrong,
>> because the GMAC_VERSION register might still be in reset
>> state, for at least 1 us after the reset is de-asserted.
> 
> From what have you got that delay value?
> 

Just try and error, with very old linux versions and old gcc versions
the synopsys_id was read out correctly most of the time (but not always),
with recent linux versions and recnet gcc versions it was read out
wrongly most of the time, but again not always.
I don't have access to the VHDL code in question, so I cannot
tell why it takes so long to get the correct values, I also do not
have more than a few hardware samples, so I cannot tell how long
this timeout must be in worst case.
Experimentally I can tell that the register is read several times
as zero immediately after the reset is de-asserted, also adding several
no-ops is not enough, adding a printk is enough, also udelay(1) seems to
be enough but I tried that not very often, and I have not access to many
hardware samples to be 100% sure about the necessary delay.
And since the udelay here is only executed once per device instance,
it seems acceptable to delay the boot for 10 us.

BTW: my hardware's synopsys id is 0x37.


Bernd.

> -Serge(y)
> 
>>
>> Add a wait for 10 us before continuing to be on the safe side.
>>
>> Signed-off-by: Bernd Edlinger <bernd.edlinger at hotmail.de>
>> ---
>>  drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 3 +++
>>  1 file changed, 3 insertions(+)
>>
>> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>> index 5801f4d50f95..e485f4db3605 100644
>> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>> @@ -7398,6 +7398,9 @@ int stmmac_dvr_probe(struct device *device,
>>  		dev_err(priv->device, "unable to bring out of ahb reset: %pe\n",
>>  			ERR_PTR(ret));
>>  
>> +	/* Wait a bit for the reset to take effect */
>> +	udelay(10);
>> +
>>  	/* Init MAC and get the capabilities */
>>  	ret = stmmac_hw_init(priv);
>>  	if (ret)
>> -- 
>> 2.39.2
>>
>>