[PATCH net-next 3/5] net: ipqess: introduce the Qualcomm IPQESS driver

[Andrew Lunn]

> > > +	for (c = 0; c < priv->info->mib_count; c++) {
> > > +		mib = &ar8327_mib[c];
> > > +		reg = QCA8K_PORT_MIB_COUNTER(port->index) + mib->offset;
> > > +
> > > +		ret = qca8k_read(priv, reg, &val);
> > > +		if (ret < 0)
> > > +			continue;
> > 
> > Given the switch is built in, is this fast? The 8k driver avoids doing
> > register reads for this.
> 
> Sorry, I don't quite understand what you mean. Are you referring to the existing 
> QCA8k DSA driver? From what I've seen, it calls qca8k_get_ethtool_stats defined 
> in qca8k-common.c and this uses the same register read.

It should actually build an Ethernet frame containing a command to get
most of the statistics in one operation. That frame is sent to the
switch over the SoCs ethernet interface. The switch replies with a
frame containing the statistics. This should be faster than doing lots
of register reads over a slow MDIO bus.

Now, given that this switch is built into the SoC, i assume the MDIO
bus is gone, so register access is fast. So you don't need to use
Ethernet frames.

	 Andrew