[PATCH net 1/1] net: stmmac: update MAC capabilities when tx queues are updated
Gan, Yi Fang
yi.fang.gan at intel.com
Tue Oct 17 19:31:36 PDT 2023
From: Michael Sit Wei Hong <michael.wei.hong.sit at intel.com>
Upon boot up, the driver will configure the MAC capabilities based on
the maximum number of tx and rx queues. When the user changes the
tx queues to single queue, the MAC should be capable of supporting Half
Duplex, but the driver does not update the MAC capabilities when it is
configured so.
Using the stmmac_reinit_queues() to check the number of tx queues
and set the MAC capabilities accordingly.
Fixes: 0366f7e06a6b ("net: stmmac: add ethtool support for get/set channels")
Cc: <stable at vger.kernel.org> # 5.17+
Signed-off-by: Michael Sit Wei Hong <michael.wei.hong.sit at intel.com>
Signed-off-by: Gan, Yi Fang <yi.fang.gan at intel.com>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index ed1a5a31a491..7ddc33fa0cb5 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -7172,6 +7172,14 @@ int stmmac_reinit_queues(struct net_device *dev, u32 rx_cnt, u32 tx_cnt)
priv->rss.table[i] = ethtool_rxfh_indir_default(i,
rx_cnt);
+ /* Half-Duplex can only work with single tx queue */
+ if (priv->plat->tx_queues_to_use > 1)
+ priv->phylink_config.mac_capabilities &=
+ ~(MAC_10HD | MAC_100HD | MAC_1000HD);
+ else
+ priv->phylink_config.mac_capabilities |=
+ (MAC_10HD | MAC_100HD | MAC_1000HD);
+
stmmac_napi_add(dev);
if (netif_running(dev))
--
2.34.1
More information about the linux-arm-kernel
mailing list