[PATCH 1/5] media: dt-bindings: media: imx335: Add supply bindings

[Sakari Ailus]

Hi Kieran,

On Tue, Oct 10, 2023 at 01:51:22AM +0100, Kieran Bingham wrote:
> Add the bindings for the supply references used on the IMX335.
> 
> Signed-off-by: Kieran Bingham <kieran.bingham at ideasonboard.com>
> ---
>  .../bindings/media/i2c/sony,imx335.yaml          | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/media/i2c/sony,imx335.yaml b/Documentation/devicetree/bindings/media/i2c/sony,imx335.yaml
> index a167dcdb3a32..1863b5608a5c 100644
> --- a/Documentation/devicetree/bindings/media/i2c/sony,imx335.yaml
> +++ b/Documentation/devicetree/bindings/media/i2c/sony,imx335.yaml
> @@ -32,6 +32,15 @@ properties:
>      description: Clock frequency from 6 to 27 MHz, 37.125MHz, 74.25MHz
>      maxItems: 1
>  
> +  avdd-supply:
> +    description: Analog power supply (2.9V)
> +
> +  ovdd-supply:
> +    description: Interface power supply (1.8V)
> +
> +  dvdd-supply:
> +    description: Digital power supply (1.2V)

I wonder what's the policy in this case --- some of the regulators are
often hard-wired and the bindings didn't have them previously either (I
wonder why, maybe they were all hard wired in the board??).

Could they be optional? The driver will need to be able to do without these
in any case.

> +
>    reset-gpios:
>      description: Reference to the GPIO connected to the XCLR pin, if any.
>      maxItems: 1
> @@ -60,6 +69,9 @@ required:
>    - compatible
>    - reg
>    - clocks
> +  - avdd-supply
> +  - ovdd-supply
> +  - dvdd-supply
>    - port
>  
>  additionalProperties: false
> @@ -79,6 +91,10 @@ examples:
>              assigned-clock-parents = <&imx335_clk_parent>;
>              assigned-clock-rates = <24000000>;
>  
> +            avdd-supply = <&camera_vdda_2v9>;
> +            ovdd-supply = <&camera_vddo_1v8>;
> +            dvdd-supply = <&camera_vddd_1v2>;
> +
>              port {
>                  imx335: endpoint {
>                      remote-endpoint = <&cam>;

-- 
Kind regards,

Sakari Ailus