[PATCH 4/7] ARM: dts: aspeed: mtmitchell: Add LEDs

Chanh Nguyen chanh at amperemail.onmicrosoft.com
Mon Oct 9 20:28:19 PDT 2023



On 05/10/2023 14:31, Krzysztof Kozlowski wrote:
> On 05/10/2023 05:55, Chanh Nguyen wrote:
>> Use gpio-leds to configure GPIOW5 to GPIO_ACTIVE_HIGH and
>> GPIO_TRANSITORY flags as a bmc ready led. The GPIOW5 pin
>> is reset when watchdog timeout occurs.
>>
>> Configure the GPIOS3 to GPIO_ACTIVE_HIGH as an identify led.
>>
>> Signed-off-by: Chanh Nguyen <chanh at os.amperecomputing.com>
>> ---
>>   .../dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts     | 13 +++++++++++++
>>   1 file changed, 13 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts
>> index b7c4f7cfad07..88693c2b2dbe 100644
>> --- a/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts
>> +++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-ampere-mtmitchell.dts
>> @@ -51,6 +51,19 @@
>>   		};
>>   	};
>>   
>> +	leds {
>> +		compatible = "gpio-leds";
>> +
>> +		bmc-ready {
> 
> Missing led name.
> 
> It does not look like you tested the DTS against bindings. Please run
> `make dtbs_check W=1` (see
> Documentation/devicetree/bindings/writing-schema.rst or
> https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
> for instructions).
> 
> Best regards,
> Krzysztof
> 

Thank Krzysztof! I'll test the DTS against bindings and update it in 
patch series v2.



More information about the linux-arm-kernel mailing list