[PATCH v2 3/4] arm64: dts: nuvoton: Add pinctrl support for ma35d1

[Krzysztof Kozlowski]

On 28/11/2023 09:37, Jacky Huang wrote:
>>> +			gpion: gpio at 40040340 {
>>> +				reg = <0x340 0x40>;
>>> +				interrupts = <GIC_SPI  105 IRQ_TYPE_LEVEL_HIGH>;
>>> +				clocks = <&clk GPN_GATE>;
>>> +				gpio-controller;
>>> +				#gpio-cells = <2>;
>>> +				interrupt-controller;
>>> +				#interrupt-cells = <2>;
>>> +			};
>>> +
>>> +			pcfg_default: pin-default {
>>> +				slew-rate = <0>;
>>> +				input-schmitt-disable;
>>> +				bias-disable;
>>> +				power-source = <1>;
>>> +				drive-strength = <17100>;
>>> +			};
>> It does not look like you tested the DTS against bindings. Please run
>> `make dtbs_check W=1` (see
>> Documentation/devicetree/bindings/writing-schema.rst or
>> https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
>> for instructions).
>>
>> Best regards,
>> Krzysztof
>>
> 
> I forgot to remove 'ma35d1-pinfunc.h' from my local copy.
> After remove the '#include <dt-bindings/pinctrl/ma35d1-pinfunc.h>', it 
> can pass
> the `make dtbs_check W=1` check.
> I will fix it in the next version.

Really? Then your bindings look wrong. Why do you mix MMIO nodes and
non-MMIO in one device node?

Best regards,
Krzysztof