[PATCH v2 3/4] arm64: dts: nuvoton: Add pinctrl support for ma35d1

[Krzysztof Kozlowski]

On 28/11/2023 07:11, Jacky Huang wrote:
> From: Jacky Huang <ychuang3 at nuvoton.com>
> 
> Add 'pinctrl' node and 'gpioa' ~ 'gpion' nodes to the dtsi of ma35d1
> SoC and describe default pin configurations.
> 
> Enable all UART nodes presented on som and iot boards, and add pinctrl
> function settings to these nodes.
> 
> Signed-off-by: Jacky Huang <ychuang3 at nuvoton.com>


> +
> +			gpion: gpio at 40040340 {
> +				reg = <0x340 0x40>;
> +				interrupts = <GIC_SPI  105 IRQ_TYPE_LEVEL_HIGH>;
> +				clocks = <&clk GPN_GATE>;
> +				gpio-controller;
> +				#gpio-cells = <2>;
> +				interrupt-controller;
> +				#interrupt-cells = <2>;
> +			};
> +
> +			pcfg_default: pin-default {
> +				slew-rate = <0>;
> +				input-schmitt-disable;
> +				bias-disable;
> +				power-source = <1>;
> +				drive-strength = <17100>;
> +			};

It does not look like you tested the DTS against bindings. Please run
`make dtbs_check W=1` (see
Documentation/devicetree/bindings/writing-schema.rst or
https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
for instructions).

Best regards,
Krzysztof