[PATCH v3 5/6] thermal: sun8i: add support for H616 THS controller

[Andre Przywara]

From: Martin Botka <martin.botka at somainline.org>

Add support for the thermal sensor found in H616 SoCs, which slightly
resembles the H6 thermal sensor controller, with a few changes like
four sensors.
Also the registers readings are wrong, unless a bit in the first SYS_CFG
register cleared, so set needs_syscon to trigger that code

Signed-off-by: Martin Botka <martin.botka at somainline.org>
Signed-off-by: Andre Przywara <andre.przywara at arm.com>
---
 drivers/thermal/sun8i_thermal.c | 73 +++++++++++++++++++++++++++++++++
 1 file changed, 73 insertions(+)

diff --git a/drivers/thermal/sun8i_thermal.c b/drivers/thermal/sun8i_thermal.c
index 920e419ce7343..9a404fa9d76a9 100644
--- a/drivers/thermal/sun8i_thermal.c
+++ b/drivers/thermal/sun8i_thermal.c
@@ -280,6 +280,64 @@ static int sun50i_h6_ths_calibrate(struct ths_device *tmdev,
 	return 0;
 }
 
+static int sun50i_h616_ths_calibrate(struct ths_device *tmdev,
+				     u16 *caldata, int callen)
+{
+	struct device *dev = tmdev->dev;
+	int i, ft_temp;
+
+	if (!caldata[0])
+		return -EINVAL;
+
+	/*
+	 * h616 efuse THS calibration data layout:
+	 *
+	 * 0      11  16     27   32     43   48    57
+	 * +----------+-----------+-----------+-----------+
+	 * |  temp |  |sensor0|   |sensor1|   |sensor2|   |
+	 * +----------+-----------+-----------+-----------+
+	 *                      ^           ^           ^
+	 *                      |           |           |
+	 *                      |           |           sensor3[11:8]
+	 *                      |           sensor3[7:4]
+	 *                      sensor3[3:0]
+	 *
+	 * The calibration data on the H616 is the ambient temperature and
+	 * sensor values that are filled during the factory test stage.
+	 *
+	 * The unit of stored FT temperature is 0.1 degree celsius.
+	 */
+	ft_temp = caldata[0] & FT_TEMP_MASK;
+
+	for (i = 0; i < tmdev->chip->sensor_num; i++) {
+		int delta, cdata, offset, reg, temp;
+
+		if (i == 3)
+			reg = (caldata[1] >> 12)
+			      | ((caldata[2] >> 12) << 4)
+			      | ((caldata[3] >> 12) << 8);
+		else
+			reg = (int)caldata[i + 1] & TEMP_CALIB_MASK;
+
+		temp = tmdev->chip->calc_temp(tmdev, i, reg);
+		delta = ((temp - ft_temp * 100) * 10) / tmdev->chip->scale;
+		cdata = CALIBRATE_DEFAULT - delta;
+		if (cdata & ~TEMP_CALIB_MASK) {
+			dev_warn(dev, "sensor%d is not calibrated.\n", i);
+
+			continue;
+		}
+
+		offset = (i % 2) * 16;
+		regmap_update_bits(tmdev->regmap,
+				   SUN50I_H6_THS_TEMP_CALIB + (i / 2 * 4),
+				   TEMP_CALIB_MASK << offset,
+				   cdata << offset);
+	}
+
+	return 0;
+}
+
 static int sun8i_ths_calibrate(struct ths_device *tmdev)
 {
 	struct nvmem_cell *calcell;
@@ -659,6 +717,20 @@ static const struct ths_thermal_chip sun50i_h6_ths = {
 	.calc_temp = sun8i_ths_calc_temp,
 };
 
+static const struct ths_thermal_chip sun50i_h616_ths = {
+	.sensor_num = 4,
+	.has_bus_clk_reset = true,
+	.needs_syscon = true,
+	.ft_deviation = 8000,
+	.offset = 263655,
+	.scale = 810,
+	.temp_data_base = SUN50I_H6_THS_TEMP_DATA,
+	.calibrate = sun50i_h616_ths_calibrate,
+	.init = sun50i_h6_thermal_init,
+	.irq_ack = sun50i_h6_irq_ack,
+	.calc_temp = sun8i_ths_calc_temp,
+};
+
 static const struct of_device_id of_ths_match[] = {
 	{ .compatible = "allwinner,sun8i-a83t-ths", .data = &sun8i_a83t_ths },
 	{ .compatible = "allwinner,sun8i-h3-ths", .data = &sun8i_h3_ths },
@@ -667,6 +739,7 @@ static const struct of_device_id of_ths_match[] = {
 	{ .compatible = "allwinner,sun50i-a100-ths", .data = &sun50i_a100_ths },
 	{ .compatible = "allwinner,sun50i-h5-ths", .data = &sun50i_h5_ths },
 	{ .compatible = "allwinner,sun50i-h6-ths", .data = &sun50i_h6_ths },
+	{ .compatible = "allwinner,sun50i-h616-ths", .data = &sun50i_h616_ths },
 	{ /* sentinel */ },
 };
 MODULE_DEVICE_TABLE(of, of_ths_match);
-- 
2.35.8