[PATCH v2 3/4] arm64: dts: freescale: Add support for the Variscite i.MX8MP DART8MCustomBoard

[Ahmad Fatoum]

On 25.10.23 18:50, Laurent Pinchart wrote:
> The DT8MCustomBoard is a carrier board for DART i.MX8-based modules.
> This device tree file adds support for the DT8MCustomBoard v2.0 with a
> connected DART-MX8M-PLUS module.
> 
> Signed-off-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
> ---


> +&eqos {
> +	mdio {
> +		ethphy1: ethernet-phy at 1 {
> +			compatible = "ethernet-phy-ieee802.3-c22";
> +			reg = <1>;
> +			eee-broken-1000t;
> +			reset-gpios = <&gpio_exp_2 0 GPIO_ACTIVE_LOW>;
> +			reset-assert-us = <10000>;
> +			reset-deassert-us = <20000>;

Ouch. So you have a PHY at address 0 (broadcast address) and a PHY at address
1 on the same bus? I think it's worth a comment whether broadcast for this
PHY here is disabled by strapping or in the bootloader.

Cheers,
Ahmad

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |