[PATCH v6 0/3] can: xilinx_can: Add ECC feature support

[Srinivas Goud]

From: Srinivas Goud <srgoud at xhdsgoud40.xilinx.com>

Add ECC feature support to Tx and Rx FIFOs for Xilinx CAN Controller.
ECC is an IP configuration option where counter registers are added in
IP for 1bit/2bit ECC errors count and reset.
Also driver reports 1bit/2bit ECC errors for FIFOs based on ECC error
interrupts.

Add xlnx,has-ecc optional property for Xilinx AXI CAN controller
to support ECC if the ECC block is enabled in the HW.

Add ethtool stats interface for getting all the ECC errors information.

There is no public documentation for it available.

---
BRANCH: linux-can-next/master

Changes in v6:
Update commit description

Changes in v5:
Fix review comments
Change the sequence of updates the stats
Add get_strings and get_sset_count stats interface
Use u64 stats helper function

Changes in v4:
Fix DT binding check warning
Update xlnx,has-ecc property description

Changes in v3:
Update mailing list
Update commit description

Changes in v2:
Address review comments
Add ethtool stats interface
Update commit description


Srinivas Goud (3):
  dt-bindings: can: xilinx_can: Add 'xlnx,has-ecc' optional property
  can: xilinx_can: Add ECC support
  can: xilinx_can: Add ethtool stats interface for ECC errors

 .../devicetree/bindings/net/can/xilinx,can.yaml    |   5 +
 drivers/net/can/xilinx_can.c                       | 159 ++++++++++++++++++++-
 2 files changed, 160 insertions(+), 4 deletions(-)

-- 
2.1.1