[PATCH 4/7] coresight: tpiu: Move ACPI support from AMBA driver to platform driver

[Sudeep Holla]

On Wed, Nov 22, 2023 at 12:32:33PM +0530, Anshuman Khandual wrote:
> On 11/15/23 19:23, James Clark wrote:
> > On 27/10/2023 08:29, Anshuman Khandual wrote:
> >> Add support for the tpiu device in the platform driver, which can then be
> >> used on ACPI based platforms. This change would now allow runtime power
> >> management for ACPI based systems. The driver would try to enable the APB
> >> clock if available.
> >>
> > [...]
> >> +#ifdef CONFIG_ACPI
> >> +static const struct acpi_device_id tpiu_acpi_ids[] = {
> >> +	{"ARMHC979", 0}, /* ARM CoreSight TPIU */
> >> +	{}
> >> +};
> >> +MODULE_DEVICE_TABLE(acpi, tpiu_acpi_ids);
> >> +#endif
> >> +
> >> +static struct platform_driver tpiu_platform_driver = {
> >> +	.probe	= tpiu_platform_probe,
> >> +	.remove	= tpiu_platform_remove,
> >> +	.driver = {
> >> +		.name			= "coresight-tpiu-platform",
> >> +		.acpi_match_table	= ACPI_PTR(tpiu_acpi_ids),
> >> +		.suppress_bind_attrs	= true,
> >> +		.pm			= &tpiu_dev_pm_ops,
> >> +	},
> >> +};
> >> +module_platform_driver(tpiu_platform_driver);
> >> +
> > 
> > Is there a special build config where this works? I get an error here
> 
> I have been testing this with a config known to work on RB5 board.
> 
> > because module_platform_driver() redefines things that are in
> > module_amba_driver() which is defined above:
> > 
> >   module_amba_driver(tpiu_driver);
> > 
> > This isn't a W=1 build or anything, just a normal one. And it applies to
> > most of the patches in this set.
> 
> You are right, I am able to recreate this problem with defconfig on
> 6.7-rc2 as well. The problem here seems to be caused by having both
> module_amba_driver() and module_platform_driver() in the same file.
> 
> #define module_amba_driver(__amba_drv) \
>         module_driver(__amba_drv, amba_driver_register, amba_driver_unregister)
> 
> #define module_platform_driver(__platform_driver) \
>         module_driver(__platform_driver, platform_driver_register, \
>                         platform_driver_unregister)
> 
> Although, AFAICT, have not seen these before - even on the defconfig.
> Just to work around this problem, there can be a common module_init()
> /module_exit() to register/unregister both AMBA and platform drivers,
> similar to etm4x_init()/etm4x_exit() setup in coresight-etm4x-core.c.

Could this be the reason why I am seeing the below error why booting with
ACPI ? I wanted to check the tables before I comment but this discussion
made me think it could be the reason, hence posting this before I got time
to analyse it.

  |  coresight-tmc-platform ARMHC97C:00: can't request region for resource [mem 0x20010000-0x20010fff]
  |  coresight-tmc-platform: probe of ARMHC97C:00 failed with error -16
  |  coresight-tmc-platform ARMHC501:00: can't request region for resource [mem 0x20070000-0x20070fff]
  |  coresight-tmc-platform: probe of ARMHC501:00 failed with error -16

--
Regards,
Sudeep