[PATCH net-next 07/15] net: dsa: mt7530: do not run mt7530_setup_port5() if port 5 is disabled

[Simon Horman]

On Sat, Nov 18, 2023 at 03:31:57PM +0300, Arınç ÜNAL wrote:
> There's no need to run all the code on mt7530_setup_port5() if port 5 is
> disabled. The only case for calling mt7530_setup_port5() from
> mt7530_setup() is when PHY muxing is enabled. That is because port 5 is not
> defined as a port on the devicetree, therefore, it cannot be controlled by
> phylink.
> 
> Because of this, run mt7530_setup_port5() if priv->p5_intf_sel is
> P5_INTF_SEL_PHY_P0 or P5_INTF_SEL_PHY_P4. Remove the P5_DISABLED case from
> mt7530_setup_port5().
> 
> Stop initialising the interface variable as the remaining cases will always
> call mt7530_setup_port5() with it initialised.
> 
> Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
> Reviewed-by: Vladimir Oltean <olteanv at gmail.com>
> ---
>  drivers/net/dsa/mt7530.c | 9 +++------
>  1 file changed, 3 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
> index fc87ec817672..1aab4c3f28b0 100644
> --- a/drivers/net/dsa/mt7530.c
> +++ b/drivers/net/dsa/mt7530.c
> @@ -942,9 +942,6 @@ static void mt7530_setup_port5(struct dsa_switch *ds, phy_interface_t interface)
>  		/* MT7530_P5_MODE_GMAC: P5 -> External phy or 2nd GMAC */
>  		val &= ~MHWTRAP_P5_DIS;
>  		break;
> -	case P5_DISABLED:
> -		interface = PHY_INTERFACE_MODE_NA;
> -		break;
>  	default:
>  		dev_err(ds->dev, "Unsupported p5_intf_sel %d\n",
>  			priv->p5_intf_sel);
> @@ -2313,8 +2310,6 @@ mt7530_setup(struct dsa_switch *ds)
>  		 * Set priv->p5_intf_sel to the appropriate value if PHY muxing
>  		 * is detected.
>  		 */
> -		interface = PHY_INTERFACE_MODE_NA;
> -
>  		for_each_child_of_node(dn, mac_np) {
>  			if (!of_device_is_compatible(mac_np,
>  						     "mediatek,eth-mac"))
> @@ -2346,7 +2341,9 @@ mt7530_setup(struct dsa_switch *ds)
>  			break;
>  		}
>  
> -		mt7530_setup_port5(ds, interface);
> +		if (priv->p5_intf_sel == P5_INTF_SEL_PHY_P0 ||
> +		    priv->p5_intf_sel == P5_INTF_SEL_PHY_P4)
> +			mt7530_setup_port5(ds, interface);

Hi Arınç,

It appears that interface is now uninitialised here.

Flagged by Smatch.

>  	}
>  
>  #ifdef CONFIG_GPIOLIB
> -- 
> 2.40.1
>