[PATCH 5/8] arm64: dts: ti: k3-am62x-sk: Enable camera peripherals

[Jai Luthra]

CSI cameras are controlled using I2C, on SK-AM62 and derivative boards
this is routed to I2C-2, so enable that bus. Also enable the nodes for
CSI-RX and DPHY-RX IPs.

Specific sensor connected to this bus will be described in the DT
overlay for each sensor.

Signed-off-by: Jai Luthra <j-luthra at ti.com>
---
 arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi b/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
index 19f57ead4ebd..21658f811307 100644
--- a/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
@@ -399,6 +399,13 @@ sii9022_out: endpoint {
 	};
 };
 
+&main_i2c2 {
+	status = "okay";
+	pinctrl-names = "default";
+	pinctrl-0 = <&main_i2c2_pins_default>;
+	clock-frequency = <400000>;
+};
+
 &sdhci0 {
 	bootph-all;
 	status = "okay";
@@ -517,3 +524,11 @@ dpi1_out: endpoint {
 		};
 	};
 };
+
+&ti_csi2rx0 {
+	status = "okay";
+};
+
+&dphy0 {
+	status = "okay";
+};

-- 
2.42.1