[PATCH net-next v3 6/8] net: phy: add calibration callbacks to phy_driver

[Andrew Lunn]

On Tue, Nov 14, 2023 at 11:55:56AM +0100, Romain Gantois wrote:
> The IPQESS integrated Ethernet switch found in the IPQ4019 SoC requires
> calibration of the PHY link when its ports are brought up. This calibration
> procedure requires knowledge of precise timings and vendor-specific
> registers on both the PHY and MAC side.
> 
> The existing PHY abstraction layer does not allow coordinating this kind of
> calibration operation between MAC drivers and PHY drivers. As a
> consequence, PHY-specific calibration information has to be included in
> Ethernet drivers, since it has to schedule the entire calibration procedure
> on it's own.
> 
> Add two callbacks that extend the PHY abstraction layer to allow MAC
> drivers to start and stop PHY calibration runs in a PHY-model-independent
> manner.

When adding new APIs, you need to add an example of both sides of
it. We can then decide if the API makes sense. I don't see a PHY
driver implementing this API.


    Andrew

---
pw-bot: cr