[PATCH 2/6] usb: cdns3-ti: move reg writes from probe into an init_hw helper

[Théo Lebrun]

The hardware initialisation register write sequence is only used at
probe. To support suspend/resume with a controller losing power, we
must redo this sequence of writes.

Extract the register write sequence to a new cdns_ti_init_hw function to
reuse it later down the road, at resume.

We keep the devicetree-parsing aspect of the sequence in probe & add a
new field in the private struct to remember the USB2 refclk rate code
computation result.

Signed-off-by: Théo Lebrun <theo.lebrun at bootlin.com>
---
 drivers/usb/cdns3/cdns3-ti.c | 76 ++++++++++++++++++++++++--------------------
 1 file changed, 41 insertions(+), 35 deletions(-)

diff --git a/drivers/usb/cdns3/cdns3-ti.c b/drivers/usb/cdns3/cdns3-ti.c
index 5945c4b1e11f..c331bcd2faeb 100644
--- a/drivers/usb/cdns3/cdns3-ti.c
+++ b/drivers/usb/cdns3/cdns3-ti.c
@@ -57,6 +57,7 @@ struct cdns_ti {
 	unsigned vbus_divider:1;
 	struct clk *usb2_refclk;
 	struct clk *lpm_clk;
+	int usb2_refclk_rate_code;
 };
 
 static const int cdns_ti_rate_table[] = {	/* in KHZ */
@@ -85,15 +86,50 @@ static inline void cdns_ti_writel(struct cdns_ti *data, u32 offset, u32 value)
 	writel(value, data->usbss + offset);
 }
 
+static void cdns_ti_init_hw(struct cdns_ti *data)
+{
+	u32 reg;
+
+	/* assert RESET */
+	reg = cdns_ti_readl(data, USBSS_W1);
+	reg &= ~USBSS_W1_PWRUP_RST;
+	cdns_ti_writel(data, USBSS_W1, reg);
+
+	/* set static config */
+	reg = cdns_ti_readl(data, USBSS_STATIC_CONFIG);
+	reg &= ~USBSS1_STATIC_PLL_REF_SEL_MASK;
+	reg |= data->usb2_refclk_rate_code << USBSS1_STATIC_PLL_REF_SEL_SHIFT;
+
+	reg &= ~USBSS1_STATIC_VBUS_SEL_MASK;
+	if (data->vbus_divider)
+		reg |= 1 << USBSS1_STATIC_VBUS_SEL_SHIFT;
+
+	cdns_ti_writel(data, USBSS_STATIC_CONFIG, reg);
+	reg = cdns_ti_readl(data, USBSS_STATIC_CONFIG);
+
+	/* set USB2_ONLY mode if requested */
+	reg = cdns_ti_readl(data, USBSS_W1);
+	if (data->usb2_only)
+		reg |= USBSS_W1_USB2_ONLY;
+
+	/* set default modestrap */
+	reg |= USBSS_W1_MODESTRAP_SEL;
+	reg &= ~USBSS_W1_MODESTRAP_MASK;
+	reg |= USBSS_MODESTRAP_MODE_NONE << USBSS_W1_MODESTRAP_SHIFT;
+	cdns_ti_writel(data, USBSS_W1, reg);
+
+	/* de-assert RESET */
+	reg |= USBSS_W1_PWRUP_RST;
+	cdns_ti_writel(data, USBSS_W1, reg);
+}
+
 static int cdns_ti_probe(struct platform_device *pdev)
 {
 	struct device *dev = &pdev->dev;
 	struct device_node *node = pdev->dev.of_node;
 	struct cdns_ti *data;
-	int error;
-	u32 reg;
-	int rate_code, i;
 	unsigned long rate;
+	int error, i;
 
 	data = devm_kzalloc(dev, sizeof(*data), GFP_KERNEL);
 	if (!data)
@@ -133,8 +169,6 @@ static int cdns_ti_probe(struct platform_device *pdev)
 		return -EINVAL;
 	}
 
-	rate_code = i;
-
 	pm_runtime_enable(dev);
 	error = pm_runtime_get_sync(dev);
 	if (error < 0) {
@@ -142,39 +176,11 @@ static int cdns_ti_probe(struct platform_device *pdev)
 		goto err;
 	}
 
-	/* assert RESET */
-	reg = cdns_ti_readl(data, USBSS_W1);
-	reg &= ~USBSS_W1_PWRUP_RST;
-	cdns_ti_writel(data, USBSS_W1, reg);
-
-	/* set static config */
-	reg = cdns_ti_readl(data, USBSS_STATIC_CONFIG);
-	reg &= ~USBSS1_STATIC_PLL_REF_SEL_MASK;
-	reg |= rate_code << USBSS1_STATIC_PLL_REF_SEL_SHIFT;
-
-	reg &= ~USBSS1_STATIC_VBUS_SEL_MASK;
 	data->vbus_divider = device_property_read_bool(dev, "ti,vbus-divider");
-	if (data->vbus_divider)
-		reg |= 1 << USBSS1_STATIC_VBUS_SEL_SHIFT;
-
-	cdns_ti_writel(data, USBSS_STATIC_CONFIG, reg);
-	reg = cdns_ti_readl(data, USBSS_STATIC_CONFIG);
-
-	/* set USB2_ONLY mode if requested */
-	reg = cdns_ti_readl(data, USBSS_W1);
 	data->usb2_only = device_property_read_bool(dev, "ti,usb2-only");
-	if (data->usb2_only)
-		reg |= USBSS_W1_USB2_ONLY;
-
-	/* set default modestrap */
-	reg |= USBSS_W1_MODESTRAP_SEL;
-	reg &= ~USBSS_W1_MODESTRAP_MASK;
-	reg |= USBSS_MODESTRAP_MODE_NONE << USBSS_W1_MODESTRAP_SHIFT;
-	cdns_ti_writel(data, USBSS_W1, reg);
+	data->usb2_refclk_rate_code = i;
 
-	/* de-assert RESET */
-	reg |= USBSS_W1_PWRUP_RST;
-	cdns_ti_writel(data, USBSS_W1, reg);
+	cdns_ti_init_hw(data);
 
 	error = of_platform_populate(node, NULL, NULL, dev);
 	if (error) {

-- 
2.41.0