[PATCH RESEND] arm64: dts: VIM3: Set the rates of the clocks for the NPU

[Jerome Brunet]

On Mon 06 Nov 2023 at 10:26, Neil Armstrong <neil.armstrong at linaro.org> wrote:

> On 06/11/2023 10:22, Tomeu Vizoso wrote:

patch title is misleading. It does not target the vim3 only but all g12
and sm1 HWs.

It should start with "arm64: dts: amlogic: g12: " instead

>> Otherwise they are left at 24MHz and the NPU runs very slowly.
>> Signed-off-by: Tomeu Vizoso <tomeu at tomeuvizoso.net>
>> Suggested-by: Lucas Stach <l.stach at pengutronix.de>
>> ---
>>   arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi | 3 +++
>>   1 file changed, 3 insertions(+)
>> diff --git a/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
>> b/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
>> index ff68b911b729..9d5eab6595d0 100644
>> --- a/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
>> +++ b/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
>> @@ -2502,6 +2502,9 @@ npu: npu at ff100000 {
>>   		clocks = <&clkc CLKID_NNA_CORE_CLK>,
>>   			 <&clkc CLKID_NNA_AXI_CLK>;
>>   		clock-names = "core", "bus";
>> +		assigned-clocks = <&clkc CLKID_NNA_CORE_CLK>,
>> +				  <&clkc CLKID_NNA_AXI_CLK>;
>> +		assigned-clock-rates = <800000000>, <800000000>;
>>   		resets = <&reset RESET_NNA>;
>>   		status = "disabled";
>>   	};
>
> Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>