[PATCH v1 06/15] ARM: dts: imx6dl: lanmcu: Configure over-current polarity for USB OTG node

[Oleksij Rempel]

This commit adds the 'over-current-active-low' flag to the USB OTG node
in the imx6dl-lanmcu device tree. This flag is necessary because the
hardware signals over-current conditions by pulling the line low.
Without this flag, the kernel could misinterpret an over-current
condition, leading to unexpected behavior.

Signed-off-by: Oleksij Rempel <o.rempel at pengutronix.de>
---
 arch/arm/boot/dts/imx6dl-lanmcu.dts | 1 +
 1 file changed, 1 insertion(+)

diff --git a/arch/arm/boot/dts/imx6dl-lanmcu.dts b/arch/arm/boot/dts/imx6dl-lanmcu.dts
index bbfa921e657d..7c62db91173b 100644
--- a/arch/arm/boot/dts/imx6dl-lanmcu.dts
+++ b/arch/arm/boot/dts/imx6dl-lanmcu.dts
@@ -257,6 +257,7 @@ &usbotg {
 	pinctrl-0 = <&pinctrl_usbotg>;
 	phy_type = "utmi";
 	dr_mode = "host";
+	over-current-active-low;
 	status = "okay";
 };
 
-- 
2.39.2