[PATCH v3 3/4] ARM: dts: stm32: Update reset declarations

[Arnaud Pouliquen]

Since the introduction of the SCMI for the management
of the MCU hold boot in OP-TEE, management of the hold boot by SMC call
is deprecated.
- Clean the st,syscfg-tz  which allows to determine if the trust
zone is enable.
- Add reset-names properties to be able to differentiate the MCU reset and
  the MCU HOLD BOOT.

Signed-off-by: Arnaud Pouliquen <arnaud.pouliquen at foss.st.com>
---
 arch/arm/boot/dts/stm32mp151.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/stm32mp151.dtsi b/arch/arm/boot/dts/stm32mp151.dtsi
index 63f4c78fcc1d..56d73d8d5cfe 100644
--- a/arch/arm/boot/dts/stm32mp151.dtsi
+++ b/arch/arm/boot/dts/stm32mp151.dtsi
@@ -1820,8 +1820,8 @@ m4_rproc: m4 at 10000000 {
 			      <0x30000000 0x40000>,
 			      <0x38000000 0x10000>;
 			resets = <&rcc MCU_R>;
+			reset-names = "mcu_rst";
 			st,syscfg-holdboot = <&rcc 0x10C 0x1>;
-			st,syscfg-tz = <&rcc 0x000 0x1>;
 			st,syscfg-pdds = <&pwr_mcu 0x0 0x1>;
 			st,syscfg-rsc-tbl = <&tamp 0x144 0xFFFFFFFF>;
 			st,syscfg-m4-state = <&tamp 0x148 0xFFFFFFFF>;
-- 
2.25.1