[PATCH v5 3/5] PCI: brcmstb: Set higher value for internal bus timeout

[Jim Quinlan]

During long periods of the PCIe RC HW being in an L1SS sleep state, there
may be a timeout on an internal bus access, even though there may not be
any PCIe access involved.  Such a timeout will cause a subsequent CPU
abort.

So, when "brcm,enable-l1ss" is observed, we increase the timeout value to
four seconds instead of using its HW default.

Tested-by: Florian Fainelli <f.fainelli at gmail.com>
Signed-off-by: Jim Quinlan <jim2101024 at gmail.com>
---
 drivers/pci/controller/pcie-brcmstb.c | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index d30636a725d7..fe0415a98c63 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -1034,6 +1034,21 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie)
 	return 0;
 }
 
+/*
+ * This extends the timeout period for an access to an internal bus.  This
+ * access timeout may occur during L1SS sleep periods even without the
+ * presence of a PCIe access.
+ */
+static void brcm_extend_rbus_timeout(struct brcm_pcie *pcie)
+{
+	/* TIMEOUT register is two registers before RGR1_SW_INIT_1 */
+	const unsigned int REG_OFFSET = PCIE_RGR1_SW_INIT_1(pcie) - 8;
+	u32 timeout_us = 4000000; /* 4 seconds, our setting for L1SS */
+
+	/* Each unit in timeout register is 1/216,000,000 seconds */
+	writel(216 * timeout_us, pcie->base + REG_OFFSET);
+}
+
 static void brcm_config_clkreq(struct brcm_pcie *pcie)
 {
 	bool l1ss = of_property_read_bool(pcie->np, "brcm,enable-l1ss");
@@ -1059,6 +1074,7 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie)
 		 * of 400ns, as specified in 3.2.5.2.2 of the PCI Express
 		 * Mini CEM 2.0 specification.
 		 */
+		brcm_extend_rbus_timeout(pcie);
 		clkreq_set |= PCIE_MISC_HARD_PCIE_HARD_DEBUG_L1SS_ENABLE_MASK;
 		dev_info(pcie->dev, "bi-dir CLKREQ# for L1SS power savings");
 	} else {
-- 
2.17.1