[PATCH net-next] net: phy: dp83869: support mii mode when rgmii strap cfg is used

[Siddharth Vadapalli]

From: Grygorii Strashko <grygorii.strashko at ti.com>

The DP83869 PHY on TI's k3-am642-evm supports both MII and RGMII
interfaces and is configured by default to use RGMII interface (strap).
However, the board design allows switching dynamically to MII interface
for testing purposes by applying different set of pinmuxes.

To support switching to MII interface, update the DP83869 PHY driver to
configure OP_MODE_DECODE.RGMII_MII_SEL(bit 5) properly when MII PHY
interface mode is requested.

Signed-off-by: Grygorii Strashko <grygorii.strashko at ti.com>
Signed-off-by: Siddharth Vadapalli <s-vadapalli at ti.com>
---

RFC patch at:
https://lore.kernel.org/r/20230425054429.3956535-3-s-vadapalli@ti.com/

Changes since RFC patch:
- Change patch subject to PATCH net-next.
- Reword commit message to indicate that the patch adds new support and
  is not intended to be a bug fix.
- Add check to ensure that MII mode is requested only with valid operational
  modes.


 drivers/net/phy/dp83869.c | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/drivers/net/phy/dp83869.c b/drivers/net/phy/dp83869.c
index 9ab5eff502b7..fa8c6fdcf301 100644
--- a/drivers/net/phy/dp83869.c
+++ b/drivers/net/phy/dp83869.c
@@ -692,8 +692,19 @@ static int dp83869_configure_mode(struct phy_device *phydev,
 	/* Below init sequence for each operational mode is defined in
 	 * section 9.4.8 of the datasheet.
 	 */
+	phy_ctrl_val = dp83869->mode;
+	if (phydev->interface == PHY_INTERFACE_MODE_MII) {
+		if (dp83869->mode == DP83869_100M_MEDIA_CONVERT ||
+		    dp83869->mode == DP83869_RGMII_100_BASE) {
+			phy_ctrl_val |= DP83869_OP_MODE_MII;
+		} else {
+			phydev_err(phydev, "selected op-mode is not valid with MII mode\n");
+			return -EINVAL;
+		}
+	}
+
 	ret = phy_write_mmd(phydev, DP83869_DEVADDR, DP83869_OP_MODE,
-			    dp83869->mode);
+			    phy_ctrl_val);
 	if (ret)
 		return ret;
 
-- 
2.25.1