[PATCH v4 39/68] clk: versatile: sp810: Add a determine_rate hook

[Maxime Ripard]

The Versatile sp810 "timerclken" clock implements a mux with a
set_parent hook, but doesn't provide a determine_rate implementation.

This is a bit odd, since set_parent() is there to, as its name implies,
change the parent of a clock. However, the most likely candidates to
trigger that parent change are either the assigned-clock-parents device
tree property or a call to clk_set_rate(), with determine_rate()
figuring out which parent is the best suited for a given rate.

This mismatch is probably due to the fact that the driver introduction
predates the determine_rate introduction, and it was never revised since
then.

The default, implicit, behaviour that has been in use so far has thus
been to simply keep using the current parent in all cases. This is also
the behaviour of the new clk_hw_determine_rate_no_reparent() helper, so
we can simply use it to make our expectation explicit.

Cc: Linus Walleij <linus.walleij at linaro.org>
Cc: Pawel Moll <pawel.moll at arm.com>
Cc: linux-arm-kernel at lists.infradead.org
Signed-off-by: Maxime Ripard <maxime at cerno.tech>
---
 drivers/clk/versatile/clk-sp810.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/clk/versatile/clk-sp810.c b/drivers/clk/versatile/clk-sp810.c
index caf0cd2fb5b6..45adac1b4630 100644
--- a/drivers/clk/versatile/clk-sp810.c
+++ b/drivers/clk/versatile/clk-sp810.c
@@ -63,6 +63,7 @@ static int clk_sp810_timerclken_set_parent(struct clk_hw *hw, u8 index)
 }
 
 static const struct clk_ops clk_sp810_timerclken_ops = {
+	.determine_rate = clk_hw_determine_rate_no_reparent,
 	.get_parent = clk_sp810_timerclken_get_parent,
 	.set_parent = clk_sp810_timerclken_set_parent,
 };

-- 
2.40.0