[PATCH v8 05/11] dt-bindings: arm: Add initial bindings for Nuvoton platform

[Krzysztof Kozlowski]

On 02/05/2023 03:31, Jacky Huang wrote:
> Dear Krzysztof,
> 
> 
> On 2023/5/1 下午 05:50, Krzysztof Kozlowski wrote:
>> On 25/04/2023 12:24, Jacky Huang wrote:
>>> From: Jacky Huang <ychuang3 at nuvoton.com>
>>>
>>> Move 'nuvoton,npcm-gcr.yaml' from 'arm/npcm' to 'soc/nuvoton'.
>>> Rename the '/arm/npcm' directory to 'arm/nuvoton'. Additionally, add
>>> bindings for ARMv8-based Nuvoton SoCs and platform boards, and include
>>> the initial bindings for ma35d1 series development boards.
>>>
>>> Signed-off-by: Jacky Huang <ychuang3 at nuvoton.com>
>>> ---
>>>   .../bindings/arm/nuvoton/nuvoton,ma35d1.yaml  | 30 +++++++++++++++++++
>>>   .../npcm.yaml => nuvoton/nuvoton,npcm.yaml}   |  2 +-
>>>   .../nuvoton/nuvoton,npcm-gcr.yaml}            |  2 +-
>>>   3 files changed, 32 insertions(+), 2 deletions(-)
>>>   create mode 100644 Documentation/devicetree/bindings/arm/nuvoton/nuvoton,ma35d1.yaml
>> I don't see any improvements here. Path in maintainers is still broken.
>>
>> Best regards,
>> Krzysztof
>>
> 
> Does this line cover 
> 'Documentation/devicetree/bindings/arm/nuvoton/nuvoton,ma35d1.yaml'?
> ==>  F:    Documentation/devicetree/bindings/*/*/*ma35*
> 
> I ran 'get_maintainer.pl' on this patch, and it was able to find 
> maintainers and looked good.
> I also ran 'make htmldocs' and did not see any warnings or errors 
> related to the .yaml files
> in this patch. However, I am still unsure where the problem lies. Can 
> you suggest any
> tools I can use to check for errors? I would greatly appreciate any 
> guidance you can provide.

Apply the patches 1 to 5 and then check if all paths from maintainers
are correct. I believe the path
Documentation/devicetree/bindings/arm/npcm/ is not.

I think I told the same last time with explanation that this patch must
correct path.

Best regards,
Krzysztof