[PATCH 1/2] dt-bindings: mailbox : arm,mhuv2: Allow for more RX interrupts

[Krzysztof Kozlowski]

On 29/03/2023 17:39, Cristian Marussi wrote:
> The ARM MHUv2 Receiver block can indeed support more interrupts, up to the
> maximum number of available channels, but anyway no more than the maximum
> number of supported interrupt for an AMBA device.
> 
> Signed-off-by: Cristian Marussi <cristian.marussi at arm.com>
> ---
> Cc: Rob Herring <robh+dt at kernel.org>
> Cc: Krzysztof Kozlowski <krzysztof.kozlowski+dt at linaro.org>
> Cc: devicetree at vger.kernel.org
> 
>  .../devicetree/bindings/mailbox/arm,mhuv2.yaml      | 13 +++++++++----
>  1 file changed, 9 insertions(+), 4 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/mailbox/arm,mhuv2.yaml b/Documentation/devicetree/bindings/mailbox/arm,mhuv2.yaml
> index a4f1fe63659a..5a57f4e2a623 100644
> --- a/Documentation/devicetree/bindings/mailbox/arm,mhuv2.yaml
> +++ b/Documentation/devicetree/bindings/mailbox/arm,mhuv2.yaml
> @@ -69,10 +69,15 @@ properties:
>  
>    interrupts:
>      description: |
> -      The MHUv2 controller always implements an interrupt in the "receiver"
> -      mode, while the interrupt in the "sender" mode was not available in the
> -      version MHUv2.0, but the later versions do have it.
> -    maxItems: 1
> +      The MHUv2 controller always implements at least an interrupt in the
> +      "receiver" mode, while the interrupt in the "sender" mode was not
> +      available in the version MHUv2.0, but the later versions do have it.
> +      In "receiver" mode, beside a single combined interrupt, there could be
> +      multiple interrupts, up to the number of implemented channels but anyway
> +      no more than the maximum number of interrupts potentially supported by
> +      AMBA.

Last sentence indicates that TX mode has something else, e.g. max 1
interrupt. Either correct the sentence or add if:then: narrowing it for TX.


Best regards,
Krzysztof