[RFC PATCH net-next v3 12/15] net: dsa: mt7530: add support for single-chip reset line

[Andrew Lunn]

On Wed, Mar 29, 2023 at 05:00:06PM +0100, Daniel Golle wrote:
> Similar to multi-chip-module MT7530 also MT7988 uses an internal
> reset line instead of using an optional reset GPIO like it is the
> case for external MT7530 and MT7531 ICs.
> Add support for internal but non-MCM reset line in preparation for
> adding support for MT7988.
> 
> Signed-off-by: Daniel Golle <daniel at makrotopia.org>
> ---
>  drivers/net/dsa/mt7530.c | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
> index c6fad2d156160..fd55ddc2d1eb3 100644
> --- a/drivers/net/dsa/mt7530.c
> +++ b/drivers/net/dsa/mt7530.c
> @@ -3066,6 +3066,12 @@ mt7530_probe_common(struct mt7530_priv *priv)
>  			dev_err(dev, "Couldn't get our reset line\n");
>  			return PTR_ERR(priv->rstc);
>  		}
> +	} else if (!priv->bus) {

!priv->bus is being used as a proxy here for MT7988. Maybe it would be
better to unconditionally use devm_reset_control_get_optional()? Or
move the reset out of mt7530_probe_common() because it is not
actually common?

	Andrew