[PATCH v2 2/4] arm64: dts: rockchip: Add FriendlyARM NanoPi R2C

[Tianling Shen]

The NanoPi R2C is a minor variant of NanoPi R2S with the on-board NIC
chip changed from rtl8211e to yt8521s, and otherwise identical to R2S.

Signed-off-by: Tianling Shen <cnsztl at gmail.com>
---
 arch/arm64/boot/dts/rockchip/Makefile         |  1 +
 .../boot/dts/rockchip/rk3328-nanopi-r2c.dts   | 40 +++++++++++++++++++
 2 files changed, 41 insertions(+)
 create mode 100644 arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2c.dts

diff --git a/arch/arm64/boot/dts/rockchip/Makefile b/arch/arm64/boot/dts/rockchip/Makefile
index a315a8117b0f..0bdcddd221f8 100644
--- a/arch/arm64/boot/dts/rockchip/Makefile
+++ b/arch/arm64/boot/dts/rockchip/Makefile
@@ -14,6 +14,7 @@ dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3326-odroid-go2-v11.dtb
 dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3326-odroid-go3.dtb
 dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3328-a1.dtb
 dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3328-evb.dtb
+dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3328-nanopi-r2c.dtb
 dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3328-nanopi-r2s.dtb
 dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3328-orangepi-r1-plus.dtb
 dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3328-rock64.dtb
diff --git a/arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2c.dts b/arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2c.dts
new file mode 100644
index 000000000000..a07a26b944a0
--- /dev/null
+++ b/arch/arm64/boot/dts/rockchip/rk3328-nanopi-r2c.dts
@@ -0,0 +1,40 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/*
+ * Copyright (c) 2021 FriendlyElec Computer Tech. Co., Ltd.
+ * (http://www.friendlyarm.com)
+ *
+ * Copyright (c) 2021-2023 Tianling Shen <cnsztl at gmail.com>
+ */
+
+/dts-v1/;
+#include "rk3328-nanopi-r2s.dts"
+
+/ {
+	model = "FriendlyElec NanoPi R2C";
+	compatible = "friendlyarm,nanopi-r2c", "rockchip,rk3328";
+};
+
+&gmac2io {
+	phy-handle = <&yt8521s>;
+	tx_delay = <0x22>;
+	rx_delay = <0x12>;
+
+	mdio {
+		/delete-node/ ethernet-phy at 1;
+
+		yt8521s: ethernet-phy at 3 {
+			compatible = "ethernet-phy-ieee802.3-c22";
+			reg = <3>;
+
+			motorcomm,clk-out-frequency-hz = <125000000>;
+			motorcomm,keep-pll-enabled;
+			motorcomm,auto-sleep-disabled;
+
+			pinctrl-0 = <&eth_phy_reset_pin>;
+			pinctrl-names = "default";
+			reset-assert-us = <10000>;
+			reset-deassert-us = <50000>;
+			reset-gpios = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>;
+		};
+	};
+};
-- 
2.40.0