[PATCH V2 0/4] clk: imx: Improve imx8mm/imx8mn LCDIF clocks

[Fabio Estevam]

On Mon, Mar 20, 2023 at 11:31 PM Adam Ford <aford173 at gmail.com> wrote:
>
> Both the i.MX8M Mini and Nano have a video_pll which can be used
> to source a clock which feeds the lcdif interface.  This interface
> currently fixes video_pll and divides down the clock feeding LCDIF.
> However, when connected to an HDMI bridge chip that supports a
> variety of video resolutions and refresh rates, the only settings
> that properly sync are ones that evenly divide from the video_pll_out
> clock.
>
> This series adds the ability for the clk-compolsite-8m to
> request a better parent clock rate if the proper clock flag is
> enable and sets that flag in the corresponding imx8mm and
> imx8mn video_pll clocks to increase the number of resolutions
> and refresh rates timings that the LCDIF can produce.
>
> This also has a side benefit of allowing the video-pll to run
> at a lower clock speed which can potentially save some power
> depending on the requested resolution and refresh rate.
>
> V2:  Split off the new imx8m_clk_hw_composite_flags definition
>      into its own patch and re-order to fix build error.
>
> Adam Ford (3):
>   clk: imx: composite-8m: Add support to determine_rate
>   clk: imx8mm: Let IMX8MM_CLK_LCDIF_PIXEL set parent rate
>   clk: imx: Let IMX8MN_CLK_DISP_PIXEL set parent rate

For the series:

Reviewed-by: Fabio Estevam <festevam at gmail.com>

Should drivers/clk/imx/clk-imx8mp.c also be adjusted in the same way?