[PATCH v6 6/6] arm64: dts: ti: k3-am62a7-sk: Enable audio on AM62A

[Jai Luthra]

Add nodes for audio codec and sound card, enable the audio serializer
(McASP1) under use and update pinmux.

The codec (TLV320AIC3106) is also supplied with a DVDD 1.8V supply from
the PMIC (TPS6593x) on the SK. As the PMIC driver and devicetree node is
missing, skip describing DVDD for now and manually set the OCMV voltage.

Signed-off-by: Jai Luthra <j-luthra at ti.com>
Reviewed-by: Jayesh Choudhary <j-choudhary at ti.com>
---
 arch/arm64/boot/dts/ti/k3-am62a7-sk.dts | 77 +++++++++++++++++++++++++++++++++
 1 file changed, 77 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts b/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts
index 063e69e45163..2ee894340be1 100644
--- a/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am62a7-sk.dts
@@ -122,6 +122,41 @@ led-0 {
 			default-state = "off";
 		};
 	};
+
+	tlv320_mclk: clk-0 {
+		#clock-cells = <0>;
+		compatible = "fixed-clock";
+		clock-frequency = <12288000>;
+	};
+
+	codec_audio: sound {
+		compatible = "simple-audio-card";
+		simple-audio-card,name = "AM62Ax-SKEVM";
+		simple-audio-card,widgets =
+			"Headphone",	"Headphone Jack",
+			"Line",		"Line In",
+			"Microphone",	"Microphone Jack";
+		simple-audio-card,routing =
+			"Headphone Jack",	"HPLOUT",
+			"Headphone Jack",	"HPROUT",
+			"LINE1L",		"Line In",
+			"LINE1R",		"Line In",
+			"MIC3R",		"Microphone Jack",
+			"Microphone Jack",	"Mic Bias";
+		simple-audio-card,format = "dsp_b";
+		simple-audio-card,bitclock-master = <&sound_master>;
+		simple-audio-card,frame-master = <&sound_master>;
+		simple-audio-card,bitclock-inversion;
+
+		simple-audio-card,cpu {
+			sound-dai = <&mcasp1>;
+		};
+
+		sound_master: simple-audio-card,codec {
+			sound-dai = <&tlv320aic3106>;
+			clocks = <&tlv320_mclk>;
+		};
+	};
 };
 
 &main_pmx0 {
@@ -200,6 +235,15 @@ AM62AX_IOPAD(0x130, PIN_INPUT, 0) /* (AB17) RGMII1_TXC */
 			AM62AX_IOPAD(0x12c, PIN_INPUT, 0) /* (W16) RGMII1_TX_CTL */
 		>;
 	};
+
+	main_mcasp1_pins_default: main-mcasp1-pins-default {
+		pinctrl-single,pins = <
+			AM62AX_IOPAD(0x090, PIN_INPUT, 2) /* (L19) GPMC0_BE0n_CLE.MCASP1_ACLKX */
+			AM62AX_IOPAD(0x098, PIN_INPUT, 2) /* (R18) GPMC0_WAIT0.MCASP1_AFSX */
+			AM62AX_IOPAD(0x08c, PIN_OUTPUT, 2) /* (K19) GPMC0_WEn.MCASP1_AXR0 */
+			AM62AX_IOPAD(0x084, PIN_INPUT, 2) /* (L18) GPMC0_ADVn_ALE.MCASP1_AXR2 */
+		>;
+	};
 };
 
 &main_i2c0 {
@@ -234,6 +278,19 @@ exp1: gpio at 22 {
 				   "MCASP1_FET_SEL", "UART1_FET_SEL",
 				   "PD_I2C_IRQ", "IO_EXP_TEST_LED";
 	};
+
+	tlv320aic3106: audio-codec at 1b {
+		#sound-dai-cells = <0>;
+		compatible = "ti,tlv320aic3106";
+		reg = <0x1b>;
+		ai3x-micbias-vg = <1>;	/* 2.0V */
+		ai3x-ocmv = <1>;	/* 1.5V */
+
+		/* Regulators */
+		AVDD-supply = <&vcc_3v3_sys>;
+		IOVDD-supply = <&vcc_3v3_sys>;
+		DRVDD-supply = <&vcc_3v3_sys>;
+	};
 };
 
 &sdhci1 {
@@ -302,3 +359,23 @@ cpsw3g_phy0: ethernet-phy at 0 {
 		ti,min-output-impedance;
 	};
 };
+
+&mcasp1 {
+	status = "okay";
+	#sound-dai-cells = <0>;
+
+	pinctrl-names = "default";
+	pinctrl-0 = <&main_mcasp1_pins_default>;
+
+	op-mode = <0>;          /* MCASP_IIS_MODE */
+	tdm-slots = <2>;
+
+	serial-dir = <  /* 0: INACTIVE, 1: TX, 2: RX */
+	       1 0 2 0
+	       0 0 0 0
+	       0 0 0 0
+	       0 0 0 0
+	>;
+	tx-num-evt = <32>;
+	rx-num-evt = <32>;
+};

-- 
2.39.2