[PATCH] p54spi: convert to devicetree

[Krzysztof Kozlowski]

On 14/03/2023 22:40, Arnd Bergmann wrote:

>>> +
>>> +  power-gpios:
>>
>> If this is GPIO driving some power pin, then it should be
>> "powerdown-gpios" (like in /bindings/gpio/gpio-consumer-common.yaml)
> 
> As far as I can tell, it's the opposite: the gpio turns the power on
> in 'high' state. I could make it GPIO_ACTIVE_LOW and call it powerdown,
> if you think that's better, but I don't think that is how it was
> meant.

Whether this is active low or high, I think does not matter. If this is
pin responsible to control the power, then we use the name
"powerdown-gpios". Effectively powerup GPIO is the same as powerdown,
just reversed.



Best regards,
Krzysztof