[PATCH 2/2] arm64: dts: freescale: imx8qxp-mek: enable cadence usb3

[Shawn Guo]

On Mon, Feb 13, 2023 at 05:22:28PM -0500, Frank Li wrote:
> Enable USB3 controller, phy and typec related nodes.
> 
> Signed-off-by: Frank Li <Frank.Li at nxp.com>
> ---
>  arch/arm64/boot/dts/freescale/imx8qxp-mek.dts | 87 +++++++++++++++++++
>  1 file changed, 87 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8qxp-mek.dts b/arch/arm64/boot/dts/freescale/imx8qxp-mek.dts
> index afa883389456..64f20ff44ba7 100644
> --- a/arch/arm64/boot/dts/freescale/imx8qxp-mek.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8qxp-mek.dts
> @@ -6,6 +6,7 @@
>  /dts-v1/;
>  
>  #include "imx8qxp.dtsi"
> +#include <dt-bindings/usb/pd.h>
>  
>  / {
>  	model = "Freescale i.MX8QXP MEK";
> @@ -28,6 +29,21 @@ reg_usdhc2_vmmc: usdhc2-vmmc {
>  		gpio = <&lsio_gpio4 19 GPIO_ACTIVE_HIGH>;
>  		enable-active-high;
>  	};
> +
> +	gpio-sbu-mux {
> +		compatible = "gpio-sbu-mux";
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&pinctrl_typec_mux>;
> +		select-gpios = <&lsio_gpio5 9 GPIO_ACTIVE_LOW>;
> +		enable-gpios = <&pca9557_a 7 GPIO_ACTIVE_LOW>;
> +		orientation-switch;
> +
> +		port {
> +			usb3_data_ss: endpoint {
> +				remote-endpoint = <&typec_con_ss>;
> +			};
> +		};
> +	};
>  };
>  
>  &dsp {
> @@ -127,6 +143,44 @@ light-sensor at 44 {
>  			};
>  		};
>  	};
> +
> +	ptn5110: tcpc at 50 {
> +		compatible = "nxp,ptn5110";
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&pinctrl_typec>;
> +		reg = <0x50>;
> +

Unneeded newline.

> +		interrupt-parent = <&lsio_gpio1>;
> +		interrupts = <3 IRQ_TYPE_LEVEL_LOW>;
> +		status = "okay";

Unneeded "okay" status.

> +
> +		port {
> +			typec_dr_sw: endpoint {
> +				remote-endpoint = <&usb3_drd_sw>;
> +			};
> +		};
> +
> +		usb_con1: connector {
> +			compatible = "usb-c-connector";
> +			label = "USB-C";
> +			power-role = "source";
> +			data-role = "dual";
> +			source-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>;
> +
> +			ports {
> +				#address-cells = <1>;
> +				#size-cells = <0>;
> +
> +				port at 1 {
> +					reg = <1>;
> +						typec_con_ss: endpoint {

Broken indent alignment.

Shawn

> +							remote-endpoint = <&usb3_data_ss>;
> +					};
> +				};
> +			};
> +		};
> +	};
> +
>  };
>  
>  &lpuart0 {
> @@ -204,6 +258,27 @@ &usdhc2 {
>  	status = "okay";
>  };
>  
> +&usb3_phy {
> +	status = "okay";
> +};
> +
> +&usbotg3 {
> +	status = "okay";
> +};
> +
> +&usbotg3_cdns3 {
> +	dr_mode = "otg";
> +	usb-role-switch;
> +	status = "okay";
> +
> +	port {
> +		usb3_drd_sw: endpoint {
> +			remote-endpoint = <&typec_dr_sw>;
> +		};
> +	};
> +};
> +
> +
>  &vpu {
>  	compatible = "nxp,imx8qxp-vpu";
>  	status = "okay";
> @@ -267,6 +342,18 @@ IMX8QXP_UART0_TX_ADMA_UART0_TX				0x06000020
>  		>;
>  	};
>  
> +	pinctrl_typec: typecgrp {
> +		fsl,pins = <
> +			IMX8QXP_SPI2_SCK_LSIO_GPIO1_IO03                        0x06000021
> +		>;
> +	};
> +
> +	pinctrl_typec_mux: typecmuxgrp {
> +		fsl,pins = <
> +			IMX8QXP_ENET0_REFCLK_125M_25M_LSIO_GPIO5_IO09           0x60
> +		>;
> +	};
> +
>  	pinctrl_usdhc1: usdhc1grp {
>  		fsl,pins = <
>  			IMX8QXP_EMMC0_CLK_CONN_EMMC0_CLK			0x06000041
> -- 
> 2.34.1
>