[PATCH 2/2] arm64: dts: ti: k3-j721e: Add overlay to enable CPSW9G ports in QSGMII mode

[Siddharth Vadapalli]

Hello Krzysztof,

On 10/03/23 14:59, Krzysztof Kozlowski wrote:
> On 10/03/2023 10:28, Siddharth Vadapalli wrote:
>> The J7 Quad Port Add-On Ethernet Card for J721E Common-Proc-Board supports
>> QSGMII mode. Use the overlay to configure CPSW9G ports in QSGMII mode.
>>
>> Add support to reset the PHY from kernel by using gpio-hog and gpio-reset.
>>
>> Add aliases for CPSW9G ports to enable kernel to fetch MAC addresses
>> directly from U-Boot.
>>
> 
> 
>> +&exp2 {
>> +	qsgmii-line-hog {
>> +		gpio-hog;
>> +		gpios = <16 GPIO_ACTIVE_HIGH>;
>> +		output-low;
>> +		line-name = "qsgmii-pwrdn-line";
>> +	};
>> +};
>> +
>> +&main_pmx0 {
>> +	mdio_pins_default: mdio_pins_default {
> 
> No underscores in node names. Didn't you already get such comments?

Sorry, I overlooked this. I am aware that underscores shouldn't be used. I will
post the v2 series fixing this.

Regards,
Siddharth.