[PATCH v1 06/14] iommu/arm-smmu-v3: Unset corresponding STE fields when s2_cfg is NULL

[Nicolin Chen]

From: Eric Auger <eric.auger at redhat.com>

Despite the spec does not seem to mention this, on some implementations,
when the STE configuration switches from an S1+S2 cfg to an S1 only one,
a C_BAD_STE error would happen if dst[3] (S2TTB) is not reset.

Explicitly reset those two higher 64b fields, to prevent that.

Note that this is not a bug at this moment, since a 2-stage translation
setup is not yet enabled, until the following patches add its support.

Reported-by: Shameer Kolothum <shameerali.kolothum.thodi at huawei.com>
Signed-off-by: Eric Auger <eric.auger at redhat.com>
Signed-off-by: Nicolin Chen <nicolinc at nvidia.com>
---
 drivers/iommu/arm/arm-smmu-v3/arm-smmu-v3.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/iommu/arm/arm-smmu-v3/arm-smmu-v3.c b/drivers/iommu/arm/arm-smmu-v3/arm-smmu-v3.c
index c5616145e2a3..29e36448d23b 100644
--- a/drivers/iommu/arm/arm-smmu-v3/arm-smmu-v3.c
+++ b/drivers/iommu/arm/arm-smmu-v3/arm-smmu-v3.c
@@ -1361,6 +1361,9 @@ static void arm_smmu_write_strtab_ent(struct arm_smmu_master *master, u32 sid,
 		dst[3] = cpu_to_le64(s2_cfg->vttbr & STRTAB_STE_3_S2TTB_MASK);
 
 		val |= FIELD_PREP(STRTAB_STE_0_CFG, STRTAB_STE_0_CFG_S2_TRANS);
+	}  else {
+		dst[2] = 0;
+		dst[3] = 0;
 	}
 
 	if (master->ats_enabled)
-- 
2.39.2