[PATCH] dt-bindings: pinctrl: k3: Introduce debounce select mux macros

[Nishanth Menon]

Introduce the debounce select mux macros to allow folks to setup
debounce configuration for pins. Each configuration selected maps
to a specific timing register as documented in appropriate Technical
Reference Manual (example:[1]).

[1] AM625x TRM (section 6.1.2.2): https://www.ti.com/lit/pdf/spruiv7
Signed-off-by: Nishanth Menon <nm at ti.com>
---
 include/dt-bindings/pinctrl/k3.h | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/include/dt-bindings/pinctrl/k3.h b/include/dt-bindings/pinctrl/k3.h
index 6bb9df1a264d..469bd29651db 100644
--- a/include/dt-bindings/pinctrl/k3.h
+++ b/include/dt-bindings/pinctrl/k3.h
@@ -11,6 +11,7 @@
 #define PULLUDEN_SHIFT		(16)
 #define PULLTYPESEL_SHIFT	(17)
 #define RXACTIVE_SHIFT		(18)
+#define DEBOUNCE_SHIFT		(11)
 
 #define PULL_DISABLE		(1 << PULLUDEN_SHIFT)
 #define PULL_ENABLE		(0 << PULLUDEN_SHIFT)
@@ -29,6 +30,14 @@
 #define PIN_INPUT_PULLUP	(INPUT_EN | PULL_UP)
 #define PIN_INPUT_PULLDOWN	(INPUT_EN | PULL_DOWN)
 
+#define PIN_DEBOUNCE_DISABLE	(0 << DEBOUNCE_SHIFT)
+#define PIN_DEBOUNCE_CONF1	(1 << DEBOUNCE_SHIFT)
+#define PIN_DEBOUNCE_CONF2	(2 << DEBOUNCE_SHIFT)
+#define PIN_DEBOUNCE_CONF3	(3 << DEBOUNCE_SHIFT)
+#define PIN_DEBOUNCE_CONF4	(4 << DEBOUNCE_SHIFT)
+#define PIN_DEBOUNCE_CONF5	(5 << DEBOUNCE_SHIFT)
+#define PIN_DEBOUNCE_CONF6	(6 << DEBOUNCE_SHIFT)
+
 #define AM62AX_IOPAD(pa, val, muxmode)		(((pa) & 0x1fff)) ((val) | (muxmode))
 #define AM62AX_MCU_IOPAD(pa, val, muxmode)	(((pa) & 0x1fff)) ((val) | (muxmode))
 
-- 
2.31.1