[PATCH net 2/2] net: dsa: mt7530: set PLL frequency only when trgmii is used

[arinc9.unal at gmail.com]

From: Arınç ÜNAL <arinc.unal at arinc9.com>

As my testing on the MCM MT7530 switch on MT7621 SoC shows, setting the PLL
frequency does not affect MII modes other than trgmii on port 5 and port 6.
So the assumption is that the operation here called "setting the PLL
frequency" actually sets the frequency of the TRGMII TX clock.

Make it so that it is set only when the trgmii mode is used.

Fixes: b8f126a8d543 ("net-next: dsa: add dsa support for Mediatek MT7530 switch")
Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
---
 drivers/net/dsa/mt7530.c | 2 --
 1 file changed, 2 deletions(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index b1a79460df0e..961306c1ac14 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -430,8 +430,6 @@ mt7530_pad_clk_setup(struct dsa_switch *ds, phy_interface_t interface)
 	switch (interface) {
 	case PHY_INTERFACE_MODE_RGMII:
 		trgint = 0;
-		/* PLL frequency: 125MHz */
-		ncpo1 = 0x0c80;
 		break;
 	case PHY_INTERFACE_MODE_TRGMII:
 		trgint = 1;
-- 
2.37.2