[PATCH] usb: xhci-mtk: set the dma max_seg_size

Mathias Nyman mathias.nyman at linux.intel.com
Fri Jun 30 04:25:40 PDT 2023


On 29.6.2023 22.19, Robin Murphy wrote:
> On 2023-06-29 19:29, Ricardo Ribalda wrote:
>> Hi Robin
>>
>> On Thu, 29 Jun 2023 at 20:11, Robin Murphy <robin.murphy at arm.com> wrote:
>>>
>>> On 2023-06-28 22:00, Ricardo Ribalda wrote:
>>>> Allow devices to have dma operations beyond 64K, and avoid warnings such
>>>> as:
>>>
>>> Hang on, is this actually correct? I just had a vague memory of XHCI
>>> having some restrictions, and sure enough according to the spec it
>>> *does* require buffers to be split at 64KB boundaries, since that's the
>>> maximum length a single TRB can encode - that's exactly the kind of
>>> constraint that the max_seg_size abstraction is intended to represent,
>>> so it seems a bit odd to be explicitly claiming a very different value.
>>>
>>> Thanks,
>>> Robin.
>>
>> I think we had a similar discussion for  93915a4170e9 ("xhci-pci: set
>> the dma max_seg_size")
>> on
>> https://lore.kernel.org/all/1fe8f8a7-c88f-0c91-e74f-4d3f2f885c89@linux.intel.com/
>>
>> ```
>> Preferred max segment size of sg list would be 64k as xHC hardware has
>> 64k TRB payload size
>> limit, but xhci driver will take care of larger segments, splitting
>> them into 64k chunks.
>> ```
> 
> OK, but it still seems off to me to claim to support something that the hardware doesn't support, and the driver has to fake, especially when it's only to paper over a warning which isn't even the driver's fault in the first place.

xHC Hardware has odd alignments and size restrictions that the driver anyway need to sort out.
The 64K is already fake, it's the most common max supported size for TRBs, but not always true.
Varies depending on TRB location in TRB ring.

xhci driver can handle any size.

> 
> The aim of the DMA_API_DEBUG_SG warnings wasn't to go round blindly adding dma_set_max_seg_size(UINT_MAX) all over the place, it was always to consider whether the dma_map_sg() call and/or the scatterlist itself are right, just as much as whether the driver may have forgotten to set an appropriate parameter. As I've already raised, in this particular case I think it's actually the debug check that's misplaced, since it's not dma_map_sg() anyway, but as it stands, the implementations of dma_alloc_noncontiguous() are definitely doing the wrong thing with respect to what it is then asking to validate.

Agree that this seems to be an issue in the DMA debugging side.
Would it need to take into account cases where device driver can support different sizes than the host controller?

> 
> Unless there is some known reason to make this change to any USB host controller *other* than that someone sees UVC allocate a >64KB buffer via this path on a system which happens to have that particular HCD, it is not the right change to make.

This would be all USB 3.x hosts, from all vendors.

keeping the 64K max seg size, and fixing the dma debug side would be optimal, but until that gets done I think
we can take this oneliner as it resolves a real world issue where USB isn't working.

Thanks
-Mathias




More information about the linux-arm-kernel mailing list