[PATCH v3 0/4] firmware: arm_scmi: Add SCMI v3.2 pincontrol protocol basic support

[Cristian Marussi]

On Tue, Jun 06, 2023 at 04:22:26PM +0000, Oleksii Moisieiev wrote:
> This Patch series is intended to introduce the potential generic driver for
> pin controls over SCMI protocol, provided in the latest beta version of DEN0056 [0].
> 
> On ARM-based systems, a separate Cortex-M based System Control Processor (SCP)
> provides control on pins, as well as with power, clocks, reset controllers. In this case,
> kernel should use one of the possible transports, described in [0] to access SCP and
> control clocks/power-domains etc. This driver is using SMC transport to communicate with SCP via
> SCMI protocol and access to the Pin Control Subsystem.
> 

Hi Oleksii,

sorry this review has been a bit delayed, I tested V3 in my setup and found no
practical issue. I'll post a few comments/remarks along the series.

Beside addressing pending comments, I suppose that the next step will be anyway
to address the upcoming changes in the new v3.2 BETA regarding support for
multiple type/value set/get operations as requested by Peng.

Thanks,
Cristian