Trying to boot mainline on Wink Hub v1

[Rogan Dawes]

Fabio provided me with a working dts, and I was able to mount and run
/sbin/init, etc from the original vendor filesystem. Obviously, there
was still lots of breakage, like console names changing, and wifi
drivers (from the 2.6.35 kernel) no longer loading.

I'm going to apply that dtb to an OpenWrt image, I think, and see if I
can get that booting.

Thanks again for the help!

Rogan

On Sun, 25 Jun 2023 at 23:38, Andrew Lunn <andrew at lunn.ch> wrote:
>
> On Sun, Jun 25, 2023 at 11:09:21PM +0200, Rogan Dawes wrote:
> > I tried adding a &nand block to my device tree, but I think it is not
> > quite as simple as that, as I got an error message complaining about
> > my additions:
> >
> > Error: arch/arm/boot/dts/imx28-wink-hub-v1.dts:40.6-11 syntax error
> > FATAL ERROR: Unable to parse input tree
>
> Looking at imx28.dtsi, it appears the nand controller is called gpmi,
> not nand. So try replacing &namd with &gpmi.
>
> Look at arch/arm/boot/dts/imx28-apf28.dts as an example.
>
>      Andrew
>