[PATCH 2/3] dt-bindings: backlight: lm3630a: add entries to control boost frequency

Heiko Stübner heiko at sntech.de
Sat Jun 17 09:34:28 PDT 2023


Am Samstag, 17. Juni 2023, 12:12:17 CEST schrieb Krzysztof Kozlowski:
> On 14/06/2023 21:08, Maximilian Weigand wrote:
> > From: Maximilian Weigand <mweigand at mweigand.net>
> > 
> > Add 'ti,boost_use_1mhz' to switch between 500 kHz and 1 MHz boost
> > converter switching frequency, and add 'ti,boost_frequency_shift' to
> > activate a frequency shift to 560 kHz or 1.12 MHz, respectively.
> > 
> > Signed-off-by: Maximilian Weigand <mweigand at mweigand.net>
> > ---
> >  .../bindings/leds/backlight/lm3630a-backlight.yaml           | 12 ++++++++++++
> >  1 file changed, 12 insertions(+)
> > 
> > diff --git a/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml b/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml
> > index 3c9b4054ed9a..ef7ea0ad2d25 100644
> > --- a/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml
> > +++ b/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml
> > @@ -33,6 +33,18 @@ properties:
> >      description: GPIO to use to enable/disable the backlight (HWEN pin).
> >      maxItems: 1
> >  
> > +  ti,boost_use_1mhz:
> 
> No underscores in property names.
> 
> > +    description: |
> 
> Do not need '|' unless you need to preserve formatting.
> 
> > +      If present, change the boost converter switching frequency from the
> > +      default 500 kHz to 1 MHz. Refer to data sheet for hardware requirements.
> > +    type: boolean
> > +
> > +  ti,boost_frequency_shift:
> > +    description: |
> > +      If present, change boost converter switching frequency from 500 kHz to
> > +      560 kHz or from 1 Mhz to 1.12 Mhz, respectively.
> 
> So just make it a property choosing the frequency, not bools, with
> proper unit suffix.

i.e.
ti,boost-frequency-hz = <x>;
with x being 500000, 560000, 1000000, 1120000

with the driver failing when the frequency is not achievable
with the two knobs of 1mhz and shift.






More information about the linux-arm-kernel mailing list