[PATCH 5/6] arm64: dts: imx8mm-phyboard-polis: Set debug uart muxing to 0x140

[Cem Tenruh]

From: Yannic Moog <y.moog at phytec.de>

Set Pull Resistors Enable bit to put signal into a defined state.

Signed-off-by: Yannic Moog <y.moog at phytec.de>
Signed-off-by: Cem Tenruh <c.tenruh at phytec.de>
---
 arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts
index cdaf15ace14f..ff5c684915f6 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts
@@ -424,8 +424,8 @@ MX8MM_IOMUXC_SAI3_TXFS_UART2_DTE_TX	0x00
 
 	pinctrl_uart3: uart3grp {
 		fsl,pins = <
-			MX8MM_IOMUXC_UART3_RXD_UART3_DCE_RX	0x40
-			MX8MM_IOMUXC_UART3_TXD_UART3_DCE_TX	0x40
+			MX8MM_IOMUXC_UART3_RXD_UART3_DCE_RX	0x140
+			MX8MM_IOMUXC_UART3_TXD_UART3_DCE_TX	0x140
 		>;
 	};
 
-- 
2.25.1