[PATCH v9 3/3] dt-bindings: mtd: marvell-nand: Convert to YAML DT scheme

[Rob Herring]

On Thu, 15 Jun 2023 16:04:47 +1200, Chris Packham wrote:
> From: Vadym Kochan <vadym.kochan at plvision.eu>
> 
> Switch the DT binding to a YAML schema to enable the DT validation.
> 
> The text binding didn't mention it as a requirement but existing usage
> has
> 
>    compatible = "marvell,armada-8k-nand-controller",
>                 "marvell,armada370-nand-controller";
> 
> so the YAML allows this in addition to the individual compatible values.
> 
> There was also an incorrect reference to dma-names being "rxtx" where
> the driver and existing device trees actually use dma-names = "data" so
> this is corrected in the conversion.
> 
> Signed-off-by: Vadym Kochan <vadym.kochan at plvision.eu>
> Signed-off-by: Chris Packham <chris.packham at alliedtelesis.co.nz>
> ---
> 
> Notes:
>     Changes in v9:
>     - depend on series from Miquel
>       https://lore.kernel.org/linux-mtd/20230606175246.190465-1-miquel.raynal@bootlin.com/
>     - enforce minimum/maximum for nand-rb
>     - move required: block for controller
>     - move unevaluatedProperties: for nand chip
>     - remove label, partitions and nand-on-flash-bbt which are covered by
>       generic schema
> 
>     Changes in v8:
>     - Mark deprecated compatible values as such
>     - Allow "marvell,armada-8k-nand-controller" without
>       "marvell,armada370-nand-controller"
>     - Make dma-names usage reflect reality
>     - Update commit message
> 
>     Changes in v7:
>     - Restore "label" and "partitions" properties (should be picked up via
>       nand-controller.yaml but aren't)
>     - Add/restore nand-on-flash-bbt and nand-ecc-mode which aren't covered
>       by nand-controller.yaml.
>     - Use "unevalautedProperties: false"
>     - Corrections for clock-names, dma-names, nand-rb and nand-ecc-strength
>     - Add pxa3xx-nand-controller example
> 
>     Changes in v6:
>     - remove properties covered by nand-controller.yaml
>     - add example using armada-8k compatible
> 
>     earlier changes:
> 
>     v5:
>        1) Get back "label" and "partitions" properties but without
>           ref to the "partition.yaml" which was wrongly used.
> 
>        2) Add "additionalProperties: false" for nand@ because all possible
>           properties are described.
> 
>     v4:
>        1) Remove "label" and "partitions" properties
> 
>        2) Use 2 clocks for A7K/8K platform which is a requirement
> 
>     v3:
>       1) Remove txt version from the MAINTAINERS list
> 
>       2) Use enum for some of compatible strings
> 
>       3) Drop:
>             #address-cells
>             #size-cells:
> 
>          as they are inherited from the nand-controller.yaml
> 
>       4) Add restriction to use 2 clocks for A8K SoC
> 
>       5) Dropped description for clock-names and extend it with
>          minItems: 1
> 
>       6) Drop description for "dmas"
> 
>       7) Use "unevalautedProperties: false"
> 
>       8) Drop quites from yaml refs.
> 
>       9) Use 4-space indentation for the example section
> 
>     v2:
>       1) Fixed warning by yamllint with incorrect indentation for compatible list
> 
>  .../bindings/mtd/marvell,nand-controller.yaml | 218 ++++++++++++++++++
>  .../devicetree/bindings/mtd/marvell-nand.txt  | 126 ----------
>  MAINTAINERS                                   |   1 -
>  3 files changed, 218 insertions(+), 127 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/mtd/marvell,nand-controller.yaml
>  delete mode 100644 Documentation/devicetree/bindings/mtd/marvell-nand.txt
> 

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.yaml: Error in referenced schema matching $id: http://devicetree.org/schemas/mtd/raw-nand-chip.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller at d0000: nand at 0: False schema does not allow {'reg': [[0]], 'label': ['main-storage'], 'nand-rb': [[0]], 'nand-ecc-mode': ['hw'], 'marvell,nand-keep-config': True, 'nand-on-flash-bbt': True, 'nand-ecc-strength': [[4]], 'nand-ecc-step-size': [[512]], 'partitions': {'compatible': ['fixed-partitions'], '#address-cells': [[1]], '#size-cells': [[1]], 'partition at 0': {'label': ['Rootfs'], 'reg': [[0, 1073741824]]}}}
	from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller at d0000: nand at 0: Unevaluated properties are not allowed ('label', 'nand-on-flash-bbt', 'partitions' were unexpected)
	from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller at 720000: nand at 0: False schema does not allow {'reg': [[0]], 'label': ['main-storage'], 'nand-rb': [[0]], 'nand-ecc-mode': ['hw'], 'nand-ecc-strength': [[8]], 'nand-ecc-step-size': [[512]]}
	from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller at 720000: nand at 0: Unevaluated properties are not allowed ('label' was unexpected)
	from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mtd/marvell,nand-controller.example.dtb: nand-controller at 43100000: nand at 0: False schema does not allow {'reg': [[0]], 'nand-rb': [[0]], 'nand-ecc-mode': ['hw'], 'marvell,nand-keep-config': True}
	from schema $id: http://devicetree.org/schemas/mtd/marvell,nand-controller.yaml#

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230615040447.3484564-4-chris.packham@alliedtelesis.co.nz

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.